Does 20k Capacity Reese M5 Fifth Wheel Hitch Have Enough Capacity to Tow RV with GVWR of 16,800 lb

Question

Question:

Hello. Out of the two 5th wheel RVs were looking at, one has a GVWR of 16,800 lbs and a hitch weight of 2,794 lbs. Would the 20k hitch suit our needs? Would it be strong enough? Thank you!

asked by: Eric

0

Expert Reply:

Yes, the 20k capacity of the Reese M5 part # RP30921 that you referenced would easily be enough to tow an RV that weighs 16,800 lbs at most. You'd have plenty of capacity to spare so there would be no need to go with the 27k model part # RP30922 instead unless you thought you'd end up towing a trailer that weighed more than 20k.

expert reply by: Jameson C

0

Answer 1

A slider hitch isn't needed with an 8 foot bed truck, but it doesn't hurt anything to use one though. Only downside is that it's going to weigh more than a stationary hitch really.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 4

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 5

Hey Jay. It sounds like you are on the right track here because a sidewinder pin box will be your only option for pulling your 5th wheel since you have a short bed truck with the Rambox. That said, you are right that the Reese Sidewinder cannot be…

view full answer...

Answer 6

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 7

The Patriot Slider part #BWRVK3270 might be a bit more noisy than the Companion slider part #BWRVK3400 due to the increased number of mounting points, 4 at the corners vs. 1 in the center. Probably not that noticeable and certainly not something…

view full answer...

Answer 8

Hey John, Thanks for the purchases and you have everything you need except the wedge. I verified directly with Reese that the correct wedge to use with the Demco Recon 5th Wheel Trailer Hitch #DM8550043 and Reese Sidewinder #RP34FR is the following:…

view full answer...

Answer 9

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 10

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

view full answer...

Answer 11

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…

view full answer...

Answer 12

So for your set up, a 2021 Ram 2500 short bed with the RamBoxes, you will need to use a Sidewinder in order to have the clearance to tow a 5th wheel. The Goose Box doesn't move the pivot point and an offset ball just won't be enough for…

view full answer...