Replacement 1-1/2" and 3" Valterra Bladex RV Waste Valves With Threaded Shafts

Question

Question:

If you remove the hub and spigot from the T40NH are you left with a T1003DSPB but with threaded instead of drilled shaft? I need to replace a 3 inch and a 1 1/2 inch valve. Both have threaded shafts that couple to existing threaded extender rods which would be difficult to replace. I need valve bodies with threaded shafts, or I could use drilled shafts if you have couplers to connect a drilled shaft to a threaded extender rod.

asked by: Ken W

0

Expert Reply:

Yes, if you were to remove the hub and spigot from the Valterra Bladex Waste Valve # T40NH you would be left with a Valterra Bladex Waste Valve Body # T1003DSPB with the threaded shaft rather than a drilled shaft.

A better option may be to use the Valterra Bladex Waste Valve Body # T1003VP and just remove the handle that is threaded on. That will take care of the 3" valve you are needing.

We have the 1-1/2" valve with the spigot and hub # T1001NH or like the other option I recommended # T1001VPM with a threaded handle that can be removed.

expert reply by: Bud M

0

Answer 1

I reached out to my contact at LaSalle Bristol regarding the LaSalle Bristol #34466N4BB72GM waste valve that you referenced and they said that they do not have just a replacement cable for that item. However, I think that you could use the Valterra…

view full answer...

Answer 2

If the Fogatti 55,000BTU InstaShower water heater is anything like the #LSB64FR it'll just have a clear hose as the drain pipe that can just be pulled off the outlet. The #LSB64FR has a drain hose coming out in the bottom right corner. From the…

view full answer...

Answer 3

If your Fogatti RV Tankless Water Heater #LSB64FR isn't regulating the temperature correctly then you would need to reach out to Fogatti for a replacement sensor since there's nothing you can do to recalibrate it as the consumer.

view full answer...

Answer 4

Typically when a tankless water heater goes cold mid shower it's because either you flow of water is too much for the heater to keep up with, or ironically the flow of water is too low and the heater doesn't think water is passing through and…

view full answer...

Answer 5

Part 18 of the Fogatti RV Tankless Water Heater #LSB64FR is the water flow sensor.

view full answer...

Answer 6

The closest thing to that in the manual is the safety feature that prevents oxygen deprivation of your Fogatti RV Tankless Water Heater #LSB64FR. On page 16 it says that after 20 - 40 minutes the water suddenly goes out than you'll need to turn…

view full answer...

Answer 7

For the Fogatti RV Tankless Water Heater, #LSB64FR an E1 Code is indicating an ignition failure or accidental flame off during ignition. If your Fogatti RV Tankless Water Heater is not receiving enough LP pressure, the ignition function would fail…

view full answer...

Answer 8

Your Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White #LSB64FR could not be reaching temperatures above 84 degrees for a few different reasons. The first thing to check is the water pressure and gas pressure as too low of…

view full answer...

Answer 9

Did you check the fuse for the Fogatti water heater? I'd try pulling that to check it and if nothing else that will reset the water heater. It's item 26 and is highlighted in the attached picture.

view full answer...

Answer 10

To install the Projected Male Slip Fitting #372216-A-MS-A to your gray tank you're going to clean the surface area and then apply some cement like the Valterra ABS Solvent Cement #A05-0303 to the shorter side of the fitting. Give it 30 minutes to…

view full answer...

Answer 11

The Projected Male Slip Fitting part #372216-A-MS-A typically installs into the opening on the black water tank and then lets you attach a 3" diameter sewer pipe.

view full answer...

Answer 12

The two flanges are essentially the same thing but made by two different companies so either the #34466V13B or the #T1009 would work great.

view full answer...

Replacement 1-1/2" and 3" Valterra Bladex RV Waste Valves With Threaded Shafts

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching