How To Remove The Drain Pipe On A Fogatti Tankless RV Water Heater

Question

Question:

How do you remove the drain pipe on a Fogatti 55000 btu insta shower 8

asked by: Nathan L

0

Expert Reply:

If the Fogatti 55,000BTU InstaShower water heater is anything like the # LSB64FR it'll just have a clear hose as the drain pipe that can just be pulled off the outlet. The # LSB64FR has a drain hose coming out in the bottom right corner. From the limited pictures I've seen of the InstaShower it appears to be in the middle towards the right side of the unit and facing down instead. Most likely it's just pushed on but it may also have a hose clamp holding it in place that you would have to loosen or cut off before pulling the hose.

expert reply by: Kevin C

0

LSB64FR Drain Hose
(click to enlarge)

Answer 1

The closest thing to that in the manual is the safety feature that prevents oxygen deprivation of your Fogatti RV Tankless Water Heater #LSB64FR. On page 16 it says that after 20 - 40 minutes the water suddenly goes out than you'll need to turn…

view full answer...

Answer 2

If your Fogatti RV Tankless Water Heater #LSB64FR isn't regulating the temperature correctly then you would need to reach out to Fogatti for a replacement sensor since there's nothing you can do to recalibrate it as the consumer.

view full answer...

Answer 3

Typically when a tankless water heater goes cold mid shower it's because either you flow of water is too much for the heater to keep up with, or ironically the flow of water is too low and the heater doesn't think water is passing through and…

view full answer...

Answer 4

Did you check the fuse for the Fogatti water heater? I'd try pulling that to check it and if nothing else that will reset the water heater. It's item 26 and is highlighted in the attached picture.

view full answer...

Answer 5

Part 18 of the Fogatti RV Tankless Water Heater #LSB64FR is the water flow sensor.

view full answer...

Answer 6

Your Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - White #LSB64FR could not be reaching temperatures above 84 degrees for a few different reasons. The first thing to check is the water pressure and gas pressure as too low of…

view full answer...

Answer 7

For the Fogatti RV Tankless Water Heater, #LSB64FR an E1 Code is indicating an ignition failure or accidental flame off during ignition. If your Fogatti RV Tankless Water Heater is not receiving enough LP pressure, the ignition function would fail…

view full answer...

Answer 8

I reached out to the manufacturer and it would seem you probably have an open/faulty Drain screw. Pull off DRAIN PIPE and use 3/16" flat blade screwdriver to make sure DRAINAGE SCREW is tightened all the way clockwise in its housing. Replace…

view full answer...

Answer 9

Yes, if you were to remove the hub and spigot from the Valterra Bladex Waste Valve #T40NH you would be left with a Valterra Bladex Waste Valve Body #T1003DSPB with the threaded shaft rather than a drilled shaft. A better option may be to use the…

view full answer...

Answer 10

I reached out to my contact at LaSalle Bristol regarding the LaSalle Bristol #34466N4BB72GM waste valve that you referenced and they said that they do not have just a replacement cable for that item. However, I think that you could use the Valterra…

view full answer...

Answer 11

The two flanges are essentially the same thing but made by two different companies so either the #34466V13B or the #T1009 would work great.

view full answer...

Answer 12

To install the Projected Male Slip Fitting #372216-A-MS-A to your gray tank you're going to clean the surface area and then apply some cement like the Valterra ABS Solvent Cement #A05-0303 to the shorter side of the fitting. Give it 30 minutes to…

view full answer...

How To Remove The Drain Pipe On A Fogatti Tankless RV Water Heater

Product Page this Question was Asked From

Continue Researching