Recommended Hitch and Wiring to Tow 3500-lbs Trailer with 2021 Volkswagen Atlas Cross Sport

Question

Question:

I will install this hitch mount on my 2021 Atlas to tow my RV. The RV weight is 3,500 lbs. Is this hitch mount strong enough or you will recommend something different?

asked by: Vidal A

0

Expert Reply:

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # C93CR that fits the 2021 VW Atlas Cross Sport has a maximum towing capacity of 5000-lbs (the same as your 2021 VW Atlas), so this hitch is rated just fine to tow a 3500-lbs trailer and will do a good job. Curt hitches have a thicker powder coat than some others on the market, which helps protect the hitch from nicks that might lead to rust and corrosion on the hitch, so it's generally what I recommend using. If you DO NOT have the Atlas Cross Sport then you'll need the Curt # C24ER

You'll also need a wiring harness, ball mount, hitch ball, hitch pin and clip to complete your towing setup. For the wiring harness I recommend using the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # TK89FR because of the reliability of Tekonsha wiring harnesses and converter boxes. To complete your towing package I recommend using an adjustable ball mount like the Curt Multi-Ball Adjustable Ball Mount for 2" Trailer Hitches # D900 since it allows you to tow a variety of different trailers with the 3 different hitch ball sizes and adjustability to be used in various rise or drop configurations to keep your trailer level.

I've linked some review videos of these parts for you to check out as well.

expert reply by: Erik B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 7

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 8

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Recommended Hitch and Wiring to Tow 3500-lbs Trailer with 2021 Volkswagen Atlas Cross Sport

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching