Correct Replacement Landing Gear Box for a Venture Landing Gear System

Question

Question:

I have a venture landing gear box WMC940RB-243085 what would be the correct replacement for this gear box.

asked by: Edward J

1

Helpful Expert Reply:

The correct replacement landing gear box for a Venture Landing Gear System is the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies part # LC276602.

expert reply by: Conner L

1

Answer 1

It is possible that there is a part number somewhere that would help identify the landing gear on your trailer. Sometimes there is information on the underside of the caps on the tops of the jacks so that is another place you can check if you…

view full answer...

Answer 2

Yes the Lippert gear box part #LC276602 would replace a Venture gear box like you have.

view full answer...

Answer 3

Thanks for the pictures. You won't need to replace the entire landing gear set. For your Venture landing gear on your 2002 Forest River Cedar Creek Fifth Wheel you will want item #LC119102 for the lead leg or item #LC119101 for the follow leg.…

view full answer...

Answer 4

In order to pick out a direct replacement for the landing gear on your 2001 sunnybrook 31bwfs we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder…

view full answer...

Answer 5

You are right on the money with the differences between the two etrailer landing gear sets; the only difference is that one comes with the manual hand crank (handle) and the other does not: - Manual Hand Crank: Landing Gear Set with Handle -…

view full answer...

Answer 6

Yes, the Lippert Motor for Electric Landing Gear part #LC142178 that you said you have will work with the Landing Gear Set part #RVLG-8HDL. The switch you have now can then be reused or we have the Lippert Components 5th Wheel RV Landing Gear Switch…

view full answer...

Answer 7

I went out to the warehouse to measure replacement gear box #LC276602. From the base of the gear box to the end of the shaft on the output side it is 4.75 inches. From the end of the shaft to the center of the pin is 1.35 inches. The diameter of the…

view full answer...

Answer 8

It sounds like you need a replacement gearbox. For a Venture replacment, that is aluminum instead of plastic, part #LC276602 is what you're looking for.

view full answer...

Answer 9

Because you have landing gear that won't operate manually and the electric motor is blowing fuses, it sounds like you have a gear box issue. If the gears were working properly the manual operation wouldn't be an issue even if there were…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 12

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Correct Replacement Landing Gear Box for a Venture Landing Gear System

Product Page this Question was Asked From

Continue Researching