Will Lippert Gear Box LC276602 Replace Venture Gear Box

Question

Question:

Would this be the direct replacement for the Venture Mfg. Co. Gear box that is in my 2006 Keystone Montana 3500RL?

asked by: Jason

0

Expert Reply:

Yes the Lippert gear box part # LC276602 would replace a Venture gear box like you have.

expert reply by: Jameson C

0

Answer 1

Given the part number, your landing gear was manufactured by Venture. The proper replacement gear box is part #LC276602 from Lippert. The gear box is also compatible with other brands of landing gear, such as Atwood, Lippert, and Stromberg-Carlson.

view full answer...

Answer 2

The correct replacement landing gear box for a Venture Landing Gear System is the Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies part #LC276602.

view full answer...

Answer 3

The replacement motor for your landing gear is #LG-142178 This will work well for you.

view full answer...

Answer 4

Yes, the Lippert Motor for Electric Landing Gear part #LC142178 that you said you have will work with the Landing Gear Set part #RVLG-8HDL. The switch you have now can then be reused or we have the Lippert Components 5th Wheel RV Landing Gear Switch…

view full answer...

Answer 5

You are right on the money with the differences between the two etrailer landing gear sets; the only difference is that one comes with the manual hand crank (handle) and the other does not: - Manual Hand Crank: Landing Gear Set with Handle -…

view full answer...

Answer 6

In order to pick out a direct replacement for the landing gear on your 2001 sunnybrook 31bwfs we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder…

view full answer...

Answer 7

It sounds like you need a replacement gearbox. For a Venture replacment, that is aluminum instead of plastic, part #LC276602 is what you're looking for.

view full answer...

Answer 8

Because you have landing gear that won't operate manually and the electric motor is blowing fuses, it sounds like you have a gear box issue. If the gears were working properly the manual operation wouldn't be an issue even if there were…

view full answer...

Answer 9

I went out to the warehouse to measure replacement gear box #LC276602. From the base of the gear box to the end of the shaft on the output side it is 4.75 inches. From the end of the shaft to the center of the pin is 1.35 inches. The diameter of the…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Will Lippert Gear Box LC276602 Replace Venture Gear Box

Product Page this Question was Asked From

Continue Researching