Voyager Camera Extension Cable Compatibility

Question

Question:

I have a Voyager WVH1100 camera on my travel trailer that was pre wired for a Voyager camera.The signal is intermittently lost when in rural areas. Im looking for an extension cable for this camera to increase the connectivity. Is this cable compatible with this camera Voyager WVH1100? if not, then do you have one that would work with it?

asked by: Ron W

0

Expert Reply:

Yes, this cable is compatible with your Voyager camera system. The cables come in varying lengths. Adding the correct length cable extension should remedy your problem.

Voyager Camera Extension Cable - 10' Long, part # VGR94FR
Voyager Camera Extension Cable - 15' Long, part # CEC15
Voyager Camera Extension Cable - 25' Long, part # CEC25
Voyager Camera Extension Cable - 34' Long, part # CEC34
Voyager Camera Extension Cable - 50' Long, part # CEC50
Voyager Camera Extension Cable - 75' Long, part # CEC75

I have included product descriptions below.

expert reply by: Mark Smith

0

Answer 1

You can use the power and ground from your current Voyager wiring to connect the Replacement Power Wire for Voyager Digital Wireless Camera #PSVCWVCMS130AP, yes. Just be sure that you also use a wireless monitor that's compatible with the camera.…

view full answer...

Answer 2

The Replacement Power Wire for Voyager Digital Wireless Camera #PSVCWVCMS130AP does include the bracket. This kit also includes 2 washers, 6 Allen head bolts as well as the needed Allen key for installation.

view full answer...

Answer 3

Yes, we do have the power wiring piece for the Voyager Camera WVCMS130AP that you referenced. It is found as part #PSVCWVCMS130AP on our site. I confirmed with my contact at Voyager that this is the correct part you need.

view full answer...

Answer 4

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be a…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Thanks for reaching out, i have a couple things for you to do. Let me explain below: *12V PWM Filter for RV Backup Camera Systems - Hardwire #VGR64VR. The newer GMC vehicles use PWM(Pulse With Modulation) in their electrical systems. The Furrion…

view full answer...

Answer 8

The Curt Crosswig part #C32DR locates the king pin of the trailer pin box centered between the two fifth wheel rails so you would not have to worry about tailgate or bed rail clearance issues. This hitch has a lot fewer moving parts than the Andersen…

view full answer...

Answer 9

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

I called the manufacturer and talked to their tech support team. Before replacing your actuator, they said: 1. Make sure constant 12-volt regarding power. 2. Check proportional valve and make sure no corrosion or trash impacting function. 3. Make…

view full answer...

Answer 12

That's weird, the 7-Way Vehicle Power Adapter for Furrion RV Observation Camera #FR87PR should allow you to use your camper at the same time as that's what it's designed for. If you want to just avoid the adapter all together, I would…

view full answer...