How Much Does The Ultra-Fab Power Twin II Electric Stabilizer UF39-941707 Weigh?

Question

Question:

how much does each unit weight ?

asked by: Glenn S

0

Expert Reply:

The Ultra-Fab Power Twin II Electric Stabilizer for Trailers and RVs - 22" Lift - 6,000 lbs # UF39-941707 you were looking at weighs in at 115lbs.

This stabilizer is designed to fit trailer frames that are between 42" and 77" wide and will take up 24" of space on each side of the frame.

I included a video of the # UF39-941707 for you to take a look at.

expert reply by: Samuel C

0

Answer 1

The measurement you will need is from the outside of the frame. The Ultra-Fab Power Twin II Stabilizers #UF39-941707 can be adjusted between 48-77 inches wide. The mounting brackets will sit under the frame with the outside of the angled metal…

view full answer...

Answer 2

Your photo did not come through but we can still help you determine if the Ultra-Fab Power Twin II Electric Stabilizer #UF39-941707 is suitable for use on your Class C Winnebago View 24J motorhome. This stabilizer fits frames from 42- to 77-inches…

view full answer...

Answer 3

The Ultra-Fab Power Twin II Electric Stabilizer, #UF39-941707, includes switches. A wireless or handheld remote is not available.

view full answer...

Answer 4

The Ultra Fab stabilizer jack part #UF39-941707 draws 30 amps of 12 volt power so it would need to run off of the trailer battery and not any AC style of power source like what is found on house interiors.

view full answer...

Answer 5

The capacity of the Ultra Fab Power Twin Stabilizers part #UF39-941707 is 6,000 lbs which means it can support up to 6,000 lbs. So typically a camper weighs quite a bit more than that so you'd need to make sure you weren't supported the full…

view full answer...

Answer 6

The only scissor jacks we carry are manual adjusting. The Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors #UF39-941705 that you referenced would be an excellent choice for stabilizer jacks on your camper or RV as long as your frame width…

view full answer...

Answer 7

The Ultra-Fab Power Twin II Electric Stabilizer #UF39-941707 that you referenced is a stabilizer kit that has a motor on each side so that it stabilizes both sides of the trailer but it is sold individually. I attached a picture that shows what you…

view full answer...

Answer 8

I have confirmed with my contacts at Ultra-Fab and the weight of Ultra-Fab Power Twin II Electric Stabilizer for Trailers #UF39-941707 is 109 pounds. This stabilizer should be mounted directly to the frame of your trailer, and will work great along…

view full answer...

Answer 9

The Ultra-Fab #UF39-941707 could be used at the rear of your motorhome, but it's not meant to be used at the front. The 6000 lb capacity of the stabilizer jack can easily handle stabilizing the rear overhang of your Class C, but the front end…

view full answer...

Answer 10

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 11

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 12

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

How Much Does The Ultra-Fab Power Twin II Electric Stabilizer UF39-941707 Weigh?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching