How to Install the Ultra-Fab Power Twin II Electric Stabilizer on the Frame

Question

Question:

You indicated that the Jacks would fit a 42 to 77 inch frame, is that measured to the inside of the frame or the outside of the frame?

asked by: Larry W

1

Helpful Expert Reply:

The measurement you will need is from the outside of the frame. The Ultra-Fab Power Twin II Stabilizers # UF39-941707 can be adjusted between 48-77 inches wide. The mounting brackets will sit under the frame with the outside of the angled metal bracket resting on the outer edge of the frame.

expert reply by: Jared P

1

Phil W.

1/10/2020

Does this mount up just like my factory original without drilling, etc

Reply

Jacob H.

1/14/2020

Without knowing what camper you have it will be hard to say. If you could provide the year, make, and model of your camper I will see what I can do to get you a fitment answer.

Reply

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Doug, thanks for reaching out! The MORryde ALLTREK 4000 #MR89DR dimensions can be a bit difficult to explain via text so I've attached an image giving you the dimensions you're asking about!

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

Hey Chad this is a great question. So the MORryde ALLTREK part #MR89DR does offer additional vertical suspension but it does sit a little taller than the equalizers it replaces so you wouldn't have to worry about your tires hitting fenders or…

view full answer...

Answer 6

Each of the leaves on the Leaf Spring #e47SR are 3/8" so this will give the spring pack a height of 1-1/2". Here is a list of our U-Bolt Kits for a 3" axle. Redline #APUBR-9 Dexter #APUBR-8 CE Smith #CE23003

view full answer...

Answer 7

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

How to Install the Ultra-Fab Power Twin II Electric Stabilizer on the Frame

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching