Recommended Replacement Converter for Magnetek Series 9000 Model 950

Question

Question:

Can I use the progressive dynamic PD 9260 C v to replace my magnetek Siri is 900 model 950

asked by: Joe

0

Expert Reply:

Yes. The Progressive Dynamics # PD9260C is the perfect replacement for your Magnetek Series 9000 model 950.

expert reply by: Erik B

0

Answer 1

I cannot be for sure but it sounds as if you are referring to a battery cutoff switch. If this is the case then I recommend using the Epicord Battery Disconnect Switch with Key part #277-000096. This switch has easy to use bolt-on terminals, comes…

view full answer...

Answer 2

Yes, the Progressive Dynamics part #PD9260C will work great as a replacement for the Magnetek 900 series model 950 that you have currently.

view full answer...

Answer 3

Yep, it sure does! Gel batteries, as well as AGM and flooded lead acid, will all work with the Progressive Dynamics battery charger you mentioned: - Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 60 Amps #PD9260C

view full answer...

Answer 4

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 7

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

view full answer...

Answer 8

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

I wish I could say yes, but as of right now they are not a fit for the 2016 models and we do not have any other suspension enhancement options. If you are trying to fight suspension sag from the tongue weight of a trailer there is a better option. A…

view full answer...