Replacement Control Board for Kwikee Steps Part Number 90950600

Question

Question:

How to know what controller #i have. I have a serial # n nothing else. Serial # 0139927

asked by: Joe B

0

Expert Reply:

The part number for your Kwikee steps' control board is going to be 90950600 and the correct replacement part from Lippert for that control board is the # LC379606.

If you also need the motor or gear box and linkage, those parts are also available and listed below in case you are seeking those replacement parts as well.

Replacement Motor with Mounting Plate for Kwikee Electric RV Steps # LC379608

Replacement Gear Box and A Linkage for Kwikee Electric RV Steps # LC379160

Motor Upgrade Kit for Kwikee Electric RV Steps # LC29VR (control board, motor, gearbox, linkage and hardware- basically everything for a complete upgrade/repair)

expert reply by: Erik B

0

Answer 1

In most cases I've seen, the control module is the likely suspect when the steps start functioning intermittently. The correct replacement module for your 909506000 is part #LC379606. We have confirmed this with Lippert on a few different…

view full answer...

Answer 2

You actually can replace the control unit on your pre-2006 Kwikee steps with the Lippert Components (LCI) Kwikee pre-IMGL/9510 Step Control with 5323 and 5327 Switches for Motorized Motorhome Entry Steps #LC379606, which is designed for use with the…

view full answer...

Answer 3

The correct replacement for the Kwikee Step Controller 909506000 is the Replacement Control Unit for Kwikee Electric RV Steps part #LC379606.

view full answer...

Answer 4

Since you can get the motor to work, and the steps are not opening/closing properly then it does sounds like the control module could be the issue. We do carry the correct replacement control module for your 909506000 Kwikee control module. -…

view full answer...

Answer 5

I spoke with my contact at Lippert regarding your Kwikee Series 32 Step Assembly. I gave him all the information you provided regarding your step assembly, along with the information from the picture you attached. He was able to confirm that the…

view full answer...

Answer 6

I reached out to my contact at Lippert Components and confirmed the replacement steps based on the 903206000 number you gave are the Lippert Components Kwikee 32 Series Double Tread Electric Step #LC372261. This is the exact replacement for your 2004…

view full answer...

Answer 7

Try tightening the band clamp that goes around the brass tee fitting on the back of the Furrion RV Tankless Water Heater part #FR93FR. If that does work loosen it and take the hose off altogether and make sure it's cut squarely without any slits…

view full answer...

Answer 8

I have a solution for you, but the Kwikee part number 909506000 has been discontinued by the manufacturer, which is why you're not seeing it. Also, the #LC379146 and #LC301702 would not be the correct parts, since they're for newer Kwikee…

view full answer...

Answer 9

The correct part may be the solution. The Replacement Control Module for Lippert Electric Coach Step #LC301702 you asked from is not a Kwikee Step controller. The Lippert Components Kwikee Control Unit for pre-IMGL/9510 Step Control with switches…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...