Replacement Control Module For a Kwikee 909506000 Control Module

Question

Question:

The part number on my kwikee module is 909506000. I hot wired the steps and the motor worked. The steps were going part out and in continously. Sounds like the module to me. Your thoughts please and do you have this part. 2004 Fleetwood Southwind 36E. Thank you

asked by: James H

0

Expert Reply:

Since you can get the motor to work, and the steps are not opening/closing properly then it does sounds like the control module could be the issue.

We do carry the correct replacement control module for your 909506000 Kwikee control module.

- Replacement Control Unit for Kwikee Electric RV Steps # LC379606

expert reply by: Scott S

0

Answer 1

You actually can replace the control unit on your pre-2006 Kwikee steps with the Lippert Components (LCI) Kwikee pre-IMGL/9510 Step Control with 5323 and 5327 Switches for Motorized Motorhome Entry Steps #LC379606, which is designed for use with…

view full answer...

Answer 2

The part number for your Kwikee steps' control board is going to be 90950600 and the correct replacement part from Lippert for that control board is the #LC379606. If you also need the motor or gear box and linkage, those parts are also…

view full answer...

Answer 3

In most cases I've seen, the control module is the likely suspect when the steps start functioning intermittently. The correct replacement module for your 909506000 is part #LC379606. We have confirmed this with Lippert on a few different…

view full answer...

Answer 4

The correct replacement for the Kwikee Step Controller 909506000 is the Replacement Control Unit for Kwikee Electric RV Steps part #LC379606.

view full answer...

Answer 5

I checked with Lippert and the correct replacement for your 909506000 control module is item #LC379606.

view full answer...

Answer 6

The Replacement Control Unit #LC379146 is the correct part for your Kwikee 909510000 step control box. This is the Lippert number since they acquired Kwikee and gave them new Lippert part numbers.

view full answer...

Answer 7

We do have a solution though there isn't an exact replacement module for a 9513 unit manufactured before 1999. Instead, what you'll need to do is upgrade your steps with the Motor Upgrade Kit for Kwikee Electric RV Steps #LC379145. This will…

view full answer...

Answer 8

The Kwikee Control Box #909506000 has been discontinued by the manufacturer. Unfortunately, if your steps were manufactured prior to February of 1999, then there are not replacement parts available and you'd need to replace the entire step. If it…

view full answer...

Answer 9

The Kwikee Control Box #909506000 has been discontinued by the manufacturer. The replacement part is determined by the date of manufacture which you can determine by looking at the current part which will have a date on it. If not, you can supply the…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Replacement Control Module For a Kwikee 909506000 Control Module

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching