Troubleshooting Leaky Clear Water Hose On Back of Furrion RV Tankless Water Heater

Question

Question:

Have a fire ion tankless hot water heater in RV. Just set up and with water pressure supplied the almost clear hose has water running from it. Rough roars to get here Has been fine. Running pretty strong

asked by: Mike P

0

Expert Reply:

Try tightening the band clamp that goes around the brass tee fitting on the back of the Furrion RV Tankless Water Heater part # FR93FR. If that does work loosen it and take the hose off altogether and make sure it's cut squarely without any slits and put it back on and retighten band clamp.

expert reply by: Jameson C

0

Answer 1

The pressure relief valve on your Furrion RV Tankless Water Heater #FR68SR could potentially be faulty from the manufacturer but before you make a warranty claim to Furrion you should test to see if the valve is correctly seated. Pull the lever on…

view full answer...

Answer 2

We do have a pressure relief valve for your Furrion RV Tankless Water Heater #FR93FR. The Camco RV Water Heater Temperature and Pressure Release Valve #CAM10423, is a 1/2 valve with a 4" probe that will help protect your RV's water…

view full answer...

Answer 3

I reached out to my contact at Lippert Components and confirmed the replacement steps based on the 903206000 number you gave are the Lippert Components Kwikee 32 Series Double Tread Electric Step #LC372261. This is the exact replacement for your…

view full answer...

Answer 4

I spoke with my contact at Lippert regarding your Kwikee Series 32 Step Assembly. I gave him all the information you provided regarding your step assembly, along with the information from the picture you attached. He was able to confirm that the…

view full answer...

Answer 5

If your Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU Item #FR93FR is coming on and then kicking off you could have an electrical, gas, or water pressure issue. The unit needs to have 12v DC running to it so you'll want to…

view full answer...

Answer 6

I assume you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590? If that is the case then there is a manual override on both the top of the motor and bottom of the leg for each jack. Since the jack is retracted…

view full answer...

Answer 7

I am sorry to hear about the issue you are having with your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590. The first thing you are going to want to do is check for blown fuses on the control board. If the fuses are…

view full answer...

Answer 8

Since you mention the pressure relief valve keeps opening, then that usually indicates that the pressure relief valve is going bad and needs to be replaced. With that being said, I recommend replacing the pressure relief valve on your Furrion RV…

view full answer...

Answer 9

Since the left side jack of your Lippert Ground Control 3.0 is not responding, and you have checked the fuses, since you mentioned switching the harnesses around and the issue then occurred on the other side I would say that is the issue over a…

view full answer...

Answer 10

In order to determine if the issue you are having with your landing gear legs clicking and popping is caused by the gear box or leg assembly you will simply need to disconnect the gear box from the legs and then test each manually. If you feel…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...