Greystone 32" Electric Fireplace Operation Instructions

Question

Question:

Hi, can you have heat on with no flamelight?

asked by: Karl M

0

Expert Reply:

The flame and heat are separate so yes, you will be able to operate the heat without the flames on and vice versa

expert reply by: Kevin C

0

Greystone Operating Instructions
(click to enlarge)

Answer 1

The correct replacement motor for your LCI motor 366043 on your Kwikee steps is Lippert Components Kwikee Motor and Screws for New IMGL Step Item #LC379147.

view full answer...

Answer 2

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

view full answer...

Answer 3

The Greystone 32" Electric Fireplace with Logs #324-000076 referenced in your question comes with a 1-year warranty from the date of purchase. It was designed to be installed in an RV that will travel down the road and see vibrations and bumps…

view full answer...

Answer 4

An E1 error code on your Furrion RV Tankless Water Heater - Gas - Automatic Pilot - 60,000 BTU #FR93FR means that it tried to ignite twice but didn't have the correct amount of gas pressure. First check to make sure your gas valves are fully…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...