Correct Curt Hitch for 2011 Subaru Impreza Hatchback with Single Exhaust

Question

Question:

Hello, will this fit my 2011 Impreza 2.5i premium hatchback single exhaust narrow body?

asked by: Todd P

0

Expert Reply:

The correct Curt Trailer Hitch Receiver for a 2011 Subaru Impreza Hatchback with Single Exhaust is actually part # C11315.

expert reply by: Conner L

0

Answer 1

All hitch makers base their designs on a vehicle's stock exhaust setup. There are just too many aftermarket items to allow them to do testing to confirm hitch compatibility with a car that has one of these. Draw-Tite hitch #DT24959 and Curt…

view full answer...

Answer 2

I checked with Curt and hitch #13390 is not a fit for your 2010 Subaru Impreza Outback Sport. The only receiver size that is going to fit your vehicle is the 1-1/4" Curt #C11315 which has a 200 lb tongue weight capacity and 2,000 lb towing…

view full answer...

Answer 3

Yes, rear fascia trimming is required to install the EcoHitch part #306-X7261 on your 2014 Subaru WRX Hatchback. The rear fascia has to be cut so that the shank of the hitch will fit. I attached a picture that shows where you'd need to trim…

view full answer...

Answer 4

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 5

I reached out to EcoHitch to see if they had any fitment notes on your 2012 Subaru Impreza WRX with the Invidia R400 Gemini Exhaust. They were not able to confirm or deny that their Stealth Trailer Hitch Receiver #306-X7261 will fit with that…

view full answer...

Answer 6

For the 2012 Impreza Hatchback, the correct hitch would be the Curt #C11286. For WRX or WRX STi Hatchback models, the correct hitch would be #C11120. The #11317 you mention is a fit for the WRX Sedan model only. Of all the hitch manufacturers we deal…

view full answer...

Answer 7

Curt trailer hitch #C11120 is only listed as a fit for 2011 Impreza hatchbacks with quad exhaust and 2012 to 2014 WRX/WRX STi hatchback models with quad exhaust. It hasn't been tested or confirmed to fit a base model. I wouldn't say it is…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Correct Curt Hitch for 2011 Subaru Impreza Hatchback with Single Exhaust

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching