Are the Curt Replacement Hook Up Brackets Part C17208 and C17008 Interchangeable

Question

Question:

Are these interchangeable with C17008 for the 14000 lb. Curt weight distribution system

asked by: Mike S

0

Expert Reply:

The Replacement Hook Up Brackets part # C17208 are interchangeable with the Replacement Lift Bracket part # C17008.

expert reply by: Conner L

0

Answer 1

There are different brackets, like the Replacement Heavy Duty Snap-Up Bracket for Reese Weight Distribution Systems #58392 which will fit tongue weight capacities up to 800 lbs. This is the same bracket that comes with the #RP6637. The #RP21501 is…

view full answer...

Answer 2

For your Reese weight distribution hitch, you will need the Replacement Lift Brackets #RP6637 for the weight distribution bar chains. For the sway bar we have the Replacement Ball-Plate Assembly #RP58062 or you can get the Reese Friction Sway Control…

view full answer...

Answer 3

What I recommend is to use some chain hangers that bolt to the side of the trailer frame, #RP58305. This method should provide you with brackets that are easier to install when compared to the regular brackets that might require trailer modification…

view full answer...

Answer 4

The Curt Weight Distribution System with Shank part #C17341 would be a good option for a 2020 Airstream Basecamp X. The weight of the items in the bed also needs to be factored into choosing the correct weight distribution system so this option gives…

view full answer...

Answer 5

Weight Distribution lift brackets can sometimes interfere with a trailer's structural components or with certain frame-mount accessory items like propane tanks. Reese offers a set of chain hangers that bolt on to the sides of your trailer frame,…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 10

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 11

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be a…

view full answer...

Answer 12

Yes, you can remove the Shark Fin Camera Mounting Bracket #FRCBRKT-BL which includes the wiring from your 2024 Forest River Flagstaff Super Lite 26FKBS for a Voyager system. The Kit #ASA24YR you found is specifically designed for trailers pre-wired…

view full answer...