Will the Curt X5 Fit a Pro Series 5th Wheel Trailer Hitch and Fit Over a Bed Mat  

The Demco #DM6140 will work with your B&W 1307 Turnoverball gooseneck hitch as is. The B&W gooseneck hitch uses a square hole for the ball, so you will just remove the ball, and the Demco #DM6140 will go directly into the square hole. That…

If your Pull Rite hitch is the ISR (industry standard rail compatible hitch), then yes the Curt X5 #16310 that you referenced would work well with your hitch. The mounting slots for the tabs on the 5th wheel measure 22 inches front to back on center.…

The difference between manual and automatic sliding 5th wheel hitches is that with a manual sliding hitch you simply move the hitch body forward or backwards before maneuvering to give yourself more clearance. Automatic sliders use a rotating head or…

I spoke with my contact at Valley and the Valley Gooseneck-to-Fifth-Wheel Adapter Plate, #V70881, will not work with the Curt slider rails. Instead, I would recommend using the Curt X5 Adapter Plate, #16310. This adapter plate will work with your…

Easiest way to tell which gooseneck hitch you have is by looking at the safety cable loops. If they are about as wide as the gooseneck ball hole and are centered with the ball hole it's an EZr, if the safety chain loops are a smaller and offset…

The bed rails used on the Curt X5 Fifth Wheel Adapter are indeed compatible with Reese standard and sliding hitches. This particular adapter is only compatible with B&W Turnover Ball Gooseneck Hitches using a square shank. I have linked you to…

The 5th Airborne Custom Wedge #SWW-03 is designed for select Draw-Tite hitches and is meant to work with the Sidewinder and 5th Airborne Sidewinder. Instead, the MORryde Orbital Pin Box Wedge for PullRite SuperGlide Hitch #MR65TR will work with…

Yes, the Reese wedge part #RP99FR is the correct wedge to use with ta Lippert Turning Point pin box and a Pullrite ISR fifth wheel hitch.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…