Compatibility of Tekonsha Wiring Harness for 1994 Toyota Pickup

Question

Question:

Does the 118379 fit 1994 pick up

asked by: Chris A

0

Expert Reply:

The T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118379 is a direct fit for a 1994 Toyota Pickup.

expert reply by: Jason S

0

Answer 1

It sounds to me like the wiring harness has a bad converter and it will need to be replaced. For this you can use the T-One Vehicle Wiring Harness, #118379. I do recommend that you do a quick inspection of the wiring on your trailer to make sure…

view full answer...

Answer 2

You can start by troubleshooting the converter. Use a circuit tester like part #PTW2993 and test the yellow wire on the input side of the converter while the left turn signal is activated. If you have power on this wire going into but not out of…

view full answer...

Answer 3

There are a host of potential issues and you will need to do some troubleshooting, which I can help you with. The first, and most important, thing to do is check all of your ground connections as they may be weak or loose; weak grounds can cause…

view full answer...

Answer 4

This sounds like a ground problem on the right side. The turn signal not working makes sense because with the brake lights, there is a constant signal coming through which is enough to make the lights illuminate on both sides like they should. But…

view full answer...

Answer 5

First, I would not immediately dismiss a bad ground simply because there are so many of them in an electrical system that could be faulty. While there may be some fluctuation in the voltage when the turn signal is cycling on and off, it seems like…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 9

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 12

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Compatibility of Tekonsha Wiring Harness for 1994 Toyota Pickup

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching