Low Profile A-Frame Trailer Tool Box

Question

Question:

I have a big Tex trailer 70 PI. Unfortunately it is tight between trailer and tongue jack. Ideally a low profile box around 12 inches. If it’s that short I can go about 18 inches deep. If the box is higher, I can only go about 12 inches deep. I would like it to be aluminum of medium strength. I can’t find what I am looking for. Any ideas?

asked by: Kevin W

0

Expert Reply:

We have a lower profile a-frame trailer tool boxes like with the UWS A-Frame Trailer Toolbox part # UWS04531 which is 13 inches tall. Front to back measure 16 inches and the width at front is 20 inches. The construction is aluminum like you are wanting as well.

I attached a dimensional drawing of the box for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The closest box we have to the dimensions you gave is the RC Manufacturing T-Series Trailer Tongue Toolbox - A-Frame - Steel - 5.2 Cu Ft - Black #313-TM362016M is 36 inches at the rear and 21-1/2 inches at the front. I've attached a diagram to…

view full answer...

Answer 2

The A-Frame Trailer Tongue Toolbox #313-TM362016M is made right here in the United States of America, as you can tell by the photo of the cutout of the bottom corner of the toolbox. It is made from 14-gauge steel for durability and there will not be…

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 6

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 7

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 8

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 9

To determine the correct cover, you will need to measure the vent opening. The most common openings are 14 1/4" x 14 1/4", and have vents that are 14" x 14". After you make your measurements, you will need to determine what type…

view full answer...

Low Profile A-Frame Trailer Tool Box

Product Page this Question was Asked From

Continue Researching