Recommended Bolt On Hangers For Aluminum Frame Trailer

Question

Question:

I am looking for a bolt on spring hanger kit for a aluminum trailer. The frame is being made out of aluminum box tube . I am going to use a 3000lb axle kit.

asked by: Jeremy S

0

Expert Reply:

Since you've got an aluminum frame trailer, I understand why you're looking for a bolt on solution. The only available bolt on hangers we have available would be the # CE14017G and # CE14016G but they are designed for slipper springs and not double-eye springs like # e77SR you were looking at. If you went this route you would want to use something like the # SP-040275 as your springs, which have a 3700-lbs capacity.

This would be the best solution available for your new aluminum trailer, but you'll also need some other parts to finish everything up. For an axle mounting kit you can use the # CE23002 and spring seat # TRSS238, which are designed for 2-3/8" diameter axles. If you also need suspension bolts you can use the # 166079.

I've linked some helpful videos on these parts that you may want to have a look at, as well.

expert reply by: Erik B

0

Answer 1

Great question! The All Terrain Landing Gear for RV Scissor Steps, #TLA8000, work with most factory scissor steps. Many steps like Brophy Scissor Steps #AS23 use rivets. You are correct - the rivets will need to be drilled out using a 1/4"…

view full answer...

Answer 2

Hey Jonathan, the All Terrain Landing Gear for TorkLift GlowStep Scissor Steps for RVs #TLA8000 that you referenced would not add additional height to the bottom of your current Torklift step setup.

view full answer...

Answer 3

For a tire to replace the 145/R12 size tires currently on your trailer, I recommend the Kenda Karrier S-Trail Radial Trailer Tire #AM10130. This is a great radial trailer tire that has a 1,220 pound maximum load at 65 psi. Note that this is a Load…

view full answer...

Answer 4

Unlike passenger car tires that have a certain range the tire needs to be inflated to, trailer tires should always be kept inflated to the maximum air pressure listed on the sidewall of the tire. We offer the Kenda Karrier 145/80-12 (aka 145/R12)…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

When you have the Brophy Camper Scissor Steps #AS25 installed at a 45 inch height they will stick out from the vehicle right at 46 inches. I attached a review video for these for you to check out as well.

view full answer...

Answer 7

I went out and measured the Brophy Camper Scissor Steps #AS25 we had in our warehouse and found them to be approximately 48" tall x 46" in length when fully extended.

view full answer...

Answer 8

For your 2022 Ford F-150 with a 5.5 foot bed the correct Thule TracRac SR ladder rack is the part #TH43002XT-508 and then for the correct tonneau cover you'd want the Revolver part #BAK56ZR as this is only option that rolls up narrow enough…

view full answer...

Answer 9

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only…

view full answer...

Answer 10

In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along…

view full answer...

Answer 11

I went ahead and checked the owner's manual for your 2022 Ford Escape, and you can absolutely tow your vehicle behind your class A RV. With that being said, you're going to need: -A baseplate kit, like the Roadmaster Direct-Connect…

view full answer...

Answer 12

I would also assume that your tires are what limits your speed rather than bearings but I would call the manufacturer just to be sure. In most cases, the limiting factor in regards to speed restrictions are the tires not the bearing which is true…

view full answer...

Recommended Bolt On Hangers For Aluminum Frame Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching