Dimensions Of The Brophy Camper Scissor Steps # AS25

Question

Question:

On the 5 step Brophy scissor step how far out does it go when extended? I’m looking to use this to access the gooseneck area in our race trailer.

asked by: Nate F

0

Expert Reply:

I went out and measured the Brophy Camper Scissor Steps # AS25 we had in our warehouse and found them to be approximately 48" tall x 46" in length when fully extended.

expert reply by: Kevin C

0

Brophy Steps # AS25 Dimensions
(click to enlarge)

Answer 1

We can set you up with new steps so that you love your whole camper setup, steps included. Based on the information you provided, I recommend taking a look at the Brophy Camper Scissor Steps #AS25. This is a 5-step assembly that can expand to between…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Al, this is a great question but since you have free-backing plates now you would never need to mess with the manual lock out of your Atwood coupler.

view full answer...

Answer 6

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Are you basically asking how much length would this coupler add to the tongue of your trailer?

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...