Will the Brophy Clamp On Camper Tie-Downs Fit a 2020 Toyota Tundra

Question

Question:

Hello, will the HSAB TIE DOWNS work with 2020 Toyota Tundra 8 ft bed?

asked by: E.J. H

0

Expert Reply:

The Brophy Clamp On Camper Tie-Downs part # HSAB are universal tie-downs used to secure a truck bed camper to a truck bed. They are universal because the manufacturer does not do any testing on specific year, make, and models. That said, we have heard back from customers using these tie-downs on earlier model Toyota Tundras so they should work on the 2020 as well. In order to complete your setup you will also need the Brophy Basic Turnbuckles w/ Hardware for Camper Tie-Downs part # TDHP.

expert reply by: Conner L

0

Answer 1

I checked with Torklift and for your 2023 Toyota Tundra we have the part #TL37CR for rear tie downs and part #TL57CR for the front.

view full answer...

Answer 2

There is no weight capacity for the Brophy Clamp On Camper Tie-Downs #HSSF. The tie-down hardware kit #TDHP, that is used to secure the camper to the #HSSF tie-downs has a weight capacity of 3,000-lbs. My contact at Brophy said the tie-downs will…

view full answer...

Answer 3

Yes, the Brophy camper tie downs like the #HSAB can be used with bed rail covers. If you check out the picture I attached you can see a set installed on a bed rail with plastic covers.

view full answer...

Answer 4

Ryan, yes the Brophy Slide In Camper Tie-Downs #HSBP should work with your 2017 Chevrolet Silverado 3500, but we have not personally tested them with your truck so you'd have to check the diagram attached and see if they'd work for you. These…

view full answer...

Answer 5

The Brophy Slide In Camper Tie-Downs #HSAB might be a fit for your 2011 Ford F-150 but you'll need to do a bit of measuring first and you'll likely need to trim out holes where the tie-downs would sit. You'll want to verify that #HSAB…

view full answer...

Answer 6

The primary advantage of frame-mounted camper tie-downs like the TorkLift #TLF2012A and #TLF3001A, which are designed to fit your Ford F-350 if it has the 6-3/4 foot bed without a step/board underneath and a factory hitch, is the stability they…

view full answer...

Answer 7

We have spoken with Brophy in the past and for a Ford F-150 with aluminum body such as your 2017 model they recommend using the Brophy Clamp On Camper Tie-Downs part #HSSF. There won't be any issues with these tie downs and an aluminum bed so…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Will the Brophy Clamp On Camper Tie-Downs Fit a 2020 Toyota Tundra

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching