Hose Will Not Lock Into Valve On D&W Inc Spray-Away Unit

Question

Question:

I am unable to connect my sprayer to my camper. No matter how hard I push it will not lock into place. Any ideas what i need to do?

asked by: Angie T

0

Expert Reply:

Yes, the female quick-connect valve has likely stopped functioning which is then why it will no longer snap back into place to hold the male end on the hose. This usually occurs from dirt getting stuck inside over time but there is also a mechanical component that can fail as well. Nonetheless, the valve will need to be replaced at the very least using the Replacement Spray-Away Quick Connect Valve part # PF247008 or you could just replace the body and valve with the D&W Inc Dual Handle Spray-Away Unit part # PF247201 for white or part # PF247701 for black.

expert reply by: Conner L

0

Answer 1

The only quick connect hoses or adapters we have are the Replacement Hose for D&W Inc Self-Storing Spray-Away Unit - 15' Coiled #PF267003 and the D&W Inc Quick Connect Hose Nozzle Adapter for Spray-Away Hose #PF247007. Both of these will…

view full answer...

Answer 2

The Replacement Hose for D&W Inc. Spray-Away RV and Marine Self-Storing Unit part #PF267003 comes with a 3/8" quick-disconnect fitting. It is designed to be used with the D&W Inc. Spray-Away RV Exterior Hose System part #PF147007. If you…

view full answer...

Answer 3

There area few differences between the 1,200 and 1,400 pound Equal-I-zer systems. The heads are different and the spring bars are different. If your tongue weight is over 1,200 pound then the 1,200 pound system is not rated high enough. When…

view full answer...

Answer 4

Quick connect style valves like the #PF247008 you referenced can be a bit challenging. I've found that the trick is getting the sleeve pulled back as far as possible and what gets in the way is tension in the mechanism. Sometimes you have to push…

view full answer...

Answer 5

The female quick connect fitting that the Hose for D&W Inc Self-Storing Spray-Away Unit part #PF267003 will attach to is the Replacement Spray-Away Quick Connect Valve part #PF247008.

view full answer...

Answer 6

The Replacement Spray-Away Quick Connect Valve - Female part #PF247008 is the replacement quick connect valve for the D&W Inc Self-Storing Spray-Away Unit part #PF147008. If the valve is leaking you most likely have some debris or dirt stuck in…

view full answer...

Answer 7

The Replacement Quick Connect Valve without the plastic cover for the D&W Spray-away unit part #PF147005 is part #PF247008. The price is on the product page.

view full answer...

Answer 8

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

The crank handle for the Lippert Components Spare Tire Winch with Offset Cable item #LC159056, is Replacement Crank Extension for Lippert Spare Tire Winch Assemblies - 35-1/2" item #LC1315411. The Spare Tire Winch item #LC159056 has a 1/2-inch…

view full answer...

Answer 12

There are going to be two parts to the handle that you will need to operate the Lippert Components Spare Tire Winch part #LC159056. The first of which is the intermediate shaft or what Lippert calls a Crank Extension part #LC1315411. This will be…

view full answer...