Exhaust Rattles After Installing Curt Hitch C11302 On a 2013 Nissan Juke
Question:
Exhaust rattle is awful below 1000 rpm. What is the best way to stop the rattle. Muffler seems pretty smug against hitch and I am hesitant to bend the post to the muffler because it might be a lot of bending.
asked by: Joe
Expert Reply:
It sounds like you already know what you need to do but if the exhaust is rattling after installing the Curt Trailer Hitch Receiver part # C11302 on your 2013 Nissan Juke there is really only one solution for this and that is to bend the exhaust hangers away from the trailer hitch. I will say however that this usually does not require any extensive bending as an 1/8" is enough to stop the rattle in most cases but I recommend you just do little by little making sure to start the vehicle and check each time that way you don't go too far. The hangers can be bent using any sold piece of metal that you can wedge between the hitch and hanger.
I have attached a help article on this process for you.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Swagman XTC2 Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: Swagman Titan Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
- Shop: Swagman Trailhead Bike Rack for 2 Bikes - 1-1/4" and 2" Hitches - Tilting
- Shop: Swagman XC2 Bike Rack for 2 bikes - 1-1/4" and 2" Hitches - Frame Mount
- Q&A: Is Frame Hole Enlargement/Temporary Exhaust Lowering Required to Install Hitch on 2013 Nissan Juke
- Q&A: Recommended Class I Hitch and 2-Bike Rack for 2012 Nissan Juke FWD
- Video: Draw-Tite Sportframe Trailer Hitch Installation - 2011 Nissan Juke
- Video: Swagman XC2 2 Bike Rack Review
- Video: Swagman XTC-2 Hitch Bike Racks Review - 2019 BMW X3
- Video: Swagman XC2 2 Bike Rack Review - 2023 Mazda CX-5
- Q&A: Differences Between Draw-Tite # 24892 and Curt # C11032 for 2012 Nissan Juke
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: Curt Class I Trailer Hitch Installation - 2011 Nissan Juke
- Video: Trailer Hitch Installation - 2012 Nissan Juke - Curt
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 68149
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: dust cap
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Search Results: 25580