Landing Gear Replacement for 2007 Keystone Cougar 29BHS
Question:
I need to replace my landing gear. On my 2007 cougar 29BHS. The existing welded brackets have a measured distance of 11 1/4 inches. My existing Landing gear doesnt even look like it has welded stops.
asked by: Keith
Helpful Expert Reply:
If your brackets are 2" tall then you most likely have the standard weld stop measurements of 15-1/2" inside to inside (see attached photo). With this being the case I recommend going with the Landing Gear Set # RVLG-8000 which has a weight rating of 8,000 lbs and offers 20-1/2" of travel. Since you have an older trailer I bet the weld stops have just been wedged in the mounting brackets which is why you are having a hard time finding them.
This set comes with the gearbox and you can either operate them manually using the hand crank # RVLG-HDL or electronically with the 12V DC motor # LC142178 and switch # LG-145236.
Products Referenced in This Question
Lippert Venture 5th Wheel RV Landing Gear Motor
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Lippert
more information >
Replacement Switch for Stromberg Carlson Electric Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Switches
- Stromberg Carlson
more information >
Replacement Crank Handle for etrailer and Ram 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Product Page this Question was Asked From
Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Bracket Dimensions of the etrailer RV Landing Gear System # RVLG-8HDL
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Article: Best Landing Gear
- Q&A: How Much Weight Can Landing Gear Hold
- Q&A: Troubleshooting Clicking Noise Coming From Landing Gear or Motor
- Q&A: Replacement Crank Handle for Ram 5th Wheel Landing Gear Compatibility With 2007 Fleetwood Nitrous TT
- Q&A: How to Know if Landing Gear Set # RVLG-8HDL Will Fit 2001 Sunnybrook 31BWFS
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Does Solar Panel Type Really Matter?
- Article: Most Popular Wheel Bearings
Brianna Q.
7/8/2020
Would RVLG-8000 work for replacement on our 2010 Keystone Laredo 321BH? The current leg shaft is 29.5" in length. Standard 15.5" between brackets. 62.5" horizontal distance between the legs.