Viking Solutions L-E-Vator Portable Loading System Folding Ability for Transport

Question

Question:

Does the unit fold up for transporting

asked by: Michael E

1

Helpful Expert Reply:

The Viking Solutions L-E-Vator Portable Loading System - 300 lbs # 310-VLV001 is designed to be folded up and moved from site to site in the back of a truck or similar vehicle. It is also designed to fit most tree stand carriers for additional portability. It weighs just 20 lbs and comes with a 1 year warranty. It is made of powder coated steel and is reinforced with galvanized steel cable to lift up to 300 lbs.

I've attached a couple pictures and a video to assist. The collapsed dimensions are 52" tall x 16" wide x 8" deep.

expert reply by: Jason S

1

click to enlarge

Answer 1

For ground clearance reasons you'd want to always remove the wheels of the Viking Solutions Tilt-N-Go II Hauler and Cargo Carrier for 2" Hitches #310-VTG002 when it's being used as a hitch mounted cargo carrier.

view full answer...

Answer 2

I have a solution for you, but the Viking Solutions Rack Jack #310-VMH001 hoist is secured via bolt on to the lower tube and there are no additional mounting holes on that lower tube it without voiding any warranty or compromising the integrity of…

view full answer...

Answer 3

Using a lift is certainly the most convenient way to go, but is not absolutely necessary. When I installed the hitch on my van, I did not need to raise the vehicle at all. Having the vehicle on jack stands or ramps would make your installation easier…

view full answer...

Answer 4

I spoke with my contact at Tekonsha, who is doubtful the controller is the issue. The voltage from the controlleer that's sent to the actuator is very minimal, it's just telling the actuator when and how hard to fire. The actuator is actually…

view full answer...

Answer 5

The Lippert Baggage Door Turn Latch, #LC213117 is 1-3/8" in length by 0.88" diameter.

view full answer...

Answer 6

There aren't any fuses in the motor or arm. It is possible that the motor burned out or the drive head gears #LC353964 have gone bad. If you need a replacement motor then you will use the Solera Power Awning Replacement Motor #LC266149. The best…

view full answer...

Answer 7

The Gen-Y Hitch 5th Wheel to Gooseneck Pin Box part #GY58GR is primarily designed for long bed trucks. It's no different than a standard fifth wheel pin box in regards to the size. If you were using a fixed hitch and standard pin box before with…

view full answer...

Answer 8

Yes, the Demco Hijacker Autoslide 5th Wheel Trailer Hitch #DM8550041 referenced in your question is compatible with the MOR/ryde pin boxes. You will just need to add the Locking Plate #DM6025. This locking plate is designed specifically for the…

view full answer...

Answer 9

Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…

view full answer...

Answer 10

When the 19x47 Curt Cargo Carrier for 1-1/4" and 2" Hitches - Steel - 300 lbs, part #C18110, is installed on your 2004 Honda CR-V you will be able to open the rear door on your 2004 Honda CR-V when the carrier is empty. Unfortunately, the…

view full answer...

Answer 11

You can tow a trailer with a weight distribution setup that does not have the spring bars connected. As long as the head of the system is attached to the shank properly (there's no reason it wouldn't be) it would work just as well as a…

view full answer...

Answer 12

The Truck Trolley Truck Bed Slide Out Tray #TR87VR has an overall length of 62-1/2" so it will fit either both the 5-1/2', and 6-1/2' bed lengths. For an 8' bed you would want the Tray #TR99VR as it will include an Extension Kit…

view full answer...