Is Kenda ST205/75R14 Radial Trailer Tire & Wheel AM32153 Balanced

Question

Question:

are these tire and wheels already balanced?

asked by: Butch

0

Expert Reply:

The tire and wheel combos we carry like # AM32153 are not machined balanced. You can have the tire and wheel combos balanced at a local tire shop if you wanted to, though it isn't necessary as they don't guide your tow vehicle, just follow behind.

expert reply by: Jameson C

0

Answer 1

You are absolutely correct in your thinking. Going with a tire that has more than needed capacity really doesn't gain you anything. Whatever the lowest rated component is in a towing setup is the overall capacity so going overkill on one portion…

view full answer...

Answer 2

A 205/75-14 tire will fit a 14 inch rim that's 5, 5-1/2, 6 or 6-1/2 inches wide. I'd be happy to make a few recommendations for a 5 on 4-1/2 inch bolt pattern wheel that's compatible with your tire size. On the more affordable end of the…

view full answer...

Answer 3

Here is a list of the 14" wheels we have which have the 5 on 4-1/2" bolt pattern and a 3.27" pilot hole. The Wheel #AM20364 you found has the common 3.19" pilot hole. Taskmaster Steel 8-Spoke Trailer Wheel #TTW460545WS1 Taskmaster…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Is Kenda ST205/75R14 Radial Trailer Tire & Wheel AM32153 Balanced

Product Page this Question was Asked From

Continue Researching