Is Bulb of Blazer Trailer Tail Light # C7493RTM Replaceable

Question

Question:

Wondering if the bulb can be replaced and if so how.

asked by: Paul C

0

Expert Reply:

The Blazer Trailer Tail Light # C7493RTM is an LED assembly which means that the bulb isn't replaceable, but due to how long LEDs last you really wouldn't have to worry about that. Unlike incandescent bulbs LEDs last a very long time so they aren't designed to be replaced.

expert reply by: Jameson C

0

Answer 1

We do have a number of options for trailer tail lights that are 4 inches in diameter, although the standard for these lights is a 3-wire system: ground, turn signal, and tail light. Your lights may have grounded through the mounting hardware, but…

view full answer...

Answer 2

Thanks for the photo. The Peterson Replacement Lens for Side Marker Light part #55-15R should be exactly what you need as it measures to be 2-3/4" wide x 2" tall. The mounting holes are 2-5/16" apart on center. The SAE AP2 04 code that…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 8

You have it right so far, the 4-way connector is just as you have stated. Remember that Yellow has a L in it so that is the left side brake/turn signal and green has a R in it so that is the right side brake/turn signal. The colors for wiring a 7-way…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 11

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen on…

view full answer...

Is Bulb of Blazer Trailer Tail Light # C7493RTM Replaceable

Product Page this Question was Asked From

Continue Researching