USA Made A-Frame 2,000 Lbs Top Wind Trailer Jack

Question

Question:

Where is this jack made? Thanks

asked by: Michael S

0

Expert Reply:

I reached out to my contact at Future 2 Solutions and he advised me that the Ultimate Trail A-Frame Jack # 322-RDJ-2K is made overseas. If you are looking for a USA made A-frame trailer jack, the Dutton Lainson jacks are all made in the USA. The A-Frame Trailer Topwind Jack # DL22781 has a 2,000lb weight rating and no drop leg like the # 322-RDJ-2K you inquired about.

expert reply by: Timothy G

0

Answer 1

Yes, the Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs #322-RDJ-2K you were looking at can be removed from the mounting bracket by removing the keeper pointed out in the included diagram, and then removing the foot. After…

view full answer...

Answer 2

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy is…

view full answer...

Answer 3

If your 2022 Chevrolet Tahoe does not have the factory tow package then the plug may not be there. If this is the case you would need to hardwire in a brake controller. If your Tahoe does have the tow package then the plug will be under the dash. The…

view full answer...

Answer 4

The factory trailer brake controller port on your 2021 Chevrolet Tahoe is located underneath the dash just to the left of the steering wheel. It will be taped to another harness so it may take a bit of looking to find. Keep in mind that if your Tahoe…

view full answer...

Answer 5

I do have an option for you but we have not yet gotten out hands on a 2019 Chevrolet Blazer therefore, have not had the chance to look for the brake controller wiring port either. I checked with both Tekonsha and Curt and it looks like they have not…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, the Curt hitch part #C77ZV is a fit for the 2023 Toyota Crown Hybrid. I attached a link to the install instructions as well as a link to an installer finder in case you wanted to find someone near you to install the hitch.

view full answer...

Answer 8

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 9

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 10

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

USA Made A-Frame 2,000 Lbs Top Wind Trailer Jack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching