Replacement Spindle for Stripped Threads on Folding Trailer

Question

Question:

One of the lug spindles on my folding trailer has stripped threads. Can I replace it? If so how? Where can I get it?

asked by: Rick

0

Expert Reply:

We do have the replacement spindles available. I've linked the page to assist so you can measure your current spindle to confirm the correct replacement. The welding of a spindle is not an easy job and should be done only by a professional welder with the proper jig equipment to ensure safety.

Your other option is to replace the entire axle. I've also attached the link to that page for all your options. You will want to ensure you have the correct capacity, hub to hub, and spring center to spring center measurements for replacement unless using the axle-less system.

expert reply by: Jason S

0

Answer 1

The overall length of the spindle part #TRU94FR measures 8-1/4 inches. I attached a review video for this spindle for you to check out as well.

view full answer...

Answer 2

If you can read me the serial number on the axle I can then call the manufacturer, Dexter, and find out the weight capacity but if not you can measure the diameter and use the chart below to determine axle capacity. The "P16" is the plant…

view full answer...

Answer 3

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

view full answer...

Answer 4

I called my contact at Bearing Buddy and they told me that the seal ring included with the Spindle Grease Seal Set, part #BB60005 will work fine on your spindle that measures 1.25 inches diameter. This set includes the steel seal ring, O-ring, and…

view full answer...

Answer 5

In order to find the correct replacement 6,000 lb trailer axle you'll need to measure the hub face and spring center of your existing axle tube and then select the one that matches below if applicable. 86-1/2" Long Hub Face &…

view full answer...

Answer 6

The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…

view full answer...

Answer 7

Yes, the temperatures you mentioned are normal. If you were getting over 200 degrees that would be a bad sign. But typically if all of the hubs are the same temperature you're good and it's only really an issue if one of the hubs is hotter…

view full answer...

Answer 8

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

view full answer...

Answer 9

The Trailer Spindle Nut #165686 that you referenced does have a thread count of 14 threads per inch.

view full answer...

Answer 10

Although there is no specific measurement for that space between the bearing and grease seal, when installing the seal you will only insert it enough so that it is flush with the hub. This is the same case if you are installing the Bearing Kit…

view full answer...

Answer 11

When installing a seal at the back of a hub the outer part of the seal will need to be flush with the hub. I have linked a video that should help. You could watch the whole video or fast forward to the 1 minute, 50 second mark to see the seal…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...