What is the Throw Measurement on the Redline T-Handle Door Latch # L4080

Question

Question:

what is the throw on the catch? Im looking to use this on a custom lift type aluminum door. Can it be mounted in any position? Thanks.

asked by: Joe

0

Expert Reply:

The Redline T-Handle Door Latch, part # L4080 can be mounted in any position you choose. You will just need to make sure the latching bar will catch, wherever the door latch is mounted.

The amount of throw on the latch is 1-1/2 inches. See the accompanying photo for the area I measured on the latch.

expert reply by: Jeff D

0

click to enlarge

Answer 1

Based on my research, the CH751 number you mentioned in your question likely refers to the type of key it uses, and not a model number for the latch itself. We do have a large selection of door latches that might work well to replace your existing…

view full answer...

Answer 2

The #L4080 mounts in a hole that measures 2-3/4" x 3-3/4". I attached a picture that has every other dimension as well. The bolt pattern is 3-1/4 inches vertically and then 3-3/4 inches horizontally.

view full answer...

Answer 3

The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom #BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running…

view full answer...

Answer 4

Yes, to use the Bauer Products Manger Door Lock for Horse Trailers #BA95FR in a right hand configuration you'd just have to flip the latch so that the locking mechanism is on the right hand side.

view full answer...

Answer 5

Check out the dimension picture I attached for the Latch Part #L4080 that you referenced. I believe the dimension you are looking for is 1/2 inch on all sides from the edge of the latch flange to the center of the mounting holes.

view full answer...

Answer 6

The hole dimensions for the Over the Seal Strap Hinge are as follows. From the center of the hinge to the holes going down the shaft is 3-1/2", 9", and 14-1/2" respectively. So the measurement you're looking for is about 3 inches…

view full answer...

Answer 7

If the hole in your door for the handle measure 2-3/4" x 3-3/4" the #L4080 would work, but most likely you would need a handle like the part #L1883 as that is more like the latching style of your current handle. This latch installs in the…

view full answer...

Answer 8

I went out to the warehouse and pulled a Replacement Locking T-Handle, #UWSTHLOCK, and took some measurements. The overall width is 4-3/4 inches. The overall height is 4-13/16 inches. The mounting holes are 3-7/8 inches apart on center from side to…

view full answer...

Answer 9

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…

view full answer...

What is the Throw Measurement on the Redline T-Handle Door Latch # L4080

Product Page this Question was Asked From

Continue Researching