Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS
Question:
Three questions: 1 do you have the hole pattern layout for this hinge please? 2 is this also available in aluminum? 3 Do you do custom modifications of this hinge?
asked by: Jeff J
Expert Reply:
The hole dimensions for the Over the Seal Strap Hinge are as follows. From the center of the hinge to the holes going down the shaft is 3-1/2", 9", and 14-1/2" respectively. So the measurement you're looking for is about 3 inches from the center of the hinge to the end of the bend. From the center of the hinge to the three holes on the bracket are 1-1/4" for both the top and bottom holes while 2-1/2" for the center hole. We do not modify, these are sold as is. We do have an aluminum one # PLR2216-AS. The stainless steel version will do well with the elements but the aluminum may be easier to modify.
Products Referenced in This Question
Over the Seal Strap Hinge - Stainless Steel - 16" Long
- Trailer Door Hinges
- Strap Hinge
- Over the Seal Hinge
- Stainless Steel
- 16 Inch Long
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Square Corner T-Strap Hinge w/ Reverse Bracket - 270 Degree - 16" Long - Aluminum
- Trailer Door Hinges
- Strap Hinge
- Corner Hinge
- Reverse Bracket
- Aluminum
- 16 Inch Long
- 2 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Product Page this Question was Asked From
Over the Seal Strap Hinge - Stainless Steel - 16" Long
- Trailer Door Hinges
- Strap Hinge
- Over the Seal Hinge
- Stainless Steel
- 16 Inch Long
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Continue Researching
- Q&A: Changing a Trailer Ramp Door To Barn Doors On A 6x14 V-Nose Enclosed Trailer
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Grommet To Use with Trailer Clearance Light # AL91RB
- Article: Trailer Maintenance Schedule
- Q&A: Replacing a 4-Way Connector on Trailer with 7 Wires
- Q&A: Thickness of TruRyde U-Bolt Plat # TRTP300175
- Q&A: Hub and Drum Assembly for AL-KO T-52 Axle
- Q&A: Is There a Replacement Door Latch for a 2007 Rage N' Toy Hauler
- Q&A: Dimensions of Square Corner Hinge with Reverse Bracket PLR2212-SSP
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Choose a Trailer Hitch Coupler
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: RV Propane 101: How Does My RV's Propane System Work?