Does Curt Front Hitch for 2004 Nissan Titan Extend Out Past Front Bumper

Question

Question:

I want to buy the front mount receiver, Curt 3199. It is very important for me to know if it will extend out past the front bumper of my nissan titan, 2 wheel drive.

asked by: Phil K

0

Expert Reply:

The Curt front hitch part # 31199 is a fit for your 2WD 2004 Nissan Titan. If you check out the install picture I attached you will see that it does not extend out past the front bumper of a vehicle it is installed on.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Good question! The blade stiffeners that come with the Detail K2 Snowplow #K2AVAL8422 don't necessarily have to be used. I reached out to my contact at Detail K2 who said that the only time that those stiffeners really need to be used is if you…

view full answer...

Answer 2

Currently the Curt Front Trailer Hitch Receiver #31199 is the only custom fit front receiver we carry for your 2004 Nissan Titan. I have included the installation instructions linked below so you can see how it mounts on your Titan and if it uses the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The Curt front hitch part #31199 is a fit for your 2WD 2004 Nissan Titan. If you check out the install picture I attached you will see that it does not extend out past the front bumper of a vehicle it is installed on.

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 7

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The best option we have to replace the AV615BHM is the Furrion RV Stereo #DV1230BL. This is also a double din stereo with a DVD player and Bluetooth connectivity; just keep in mind it does require a cutout of 6-15/16" wide x 4" tall x…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Does Curt Front Hitch for 2004 Nissan Titan Extend Out Past Front Bumper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching