Trailer Hitch Installation - 2003 Ford F-250 - Draw-Tite Video

The only lift kit we offer for this application is the Correct Track Trailer Alignment and Lift Kit part #RR23QX which is basically a leaf spring hanger extension that will provide a lift of 1-1/4" or 2-1/4". It can be used with…

You are doing the right thing by doing the research first. There is a lot of conflicting information out there so let me break it down for you and I will provide some part recommendations at the end. Basically, if you want to tow a 5th wheel trailer,…

To install the Draw Tite hitch part #65022 on your 1999 Ford F-350 you will need a 3/4 inch wrench, a 15 mm wrench, an 18 mm wrench, and a 5/8 inch drill bit. Check out the install video I attached for more info on the install as well.

While the HitchMate TireStep #HE4040 will work on the rear dually tires on your 2000 Ford F-350 cab and chassis, it will not work on the front wheels and tires since the wheel protrudes out past the tire. We do have the Folding Step Stool #PT36NJ…

I did some research and found instructions for installing the RanchHand Legend Grille Guard on your 2011 F-250 4x4. You can check out the attached photo that shows where a front hitch is mounted on a Ford F-250. You may find that the bottom bar on…

The previous generations of the Correct Track had some issues with brackets bending but the current generations like the single axle part #LC87120 and tandem axle #RR23QX have had all of that addressed and fixed.

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

The front-mount hitch you referenced, Curt #31038, is a correct fit for your 2003 Ford F-150 4 x 4 with factory tow hooks. You will use the original hardware that secures the tow hooks in place, along with the two supplied carriage bolts that come…

The front mount trailer hitch I recommend for your 2005 Ford F-350 is the Curt Front Mount Trailer Hitch Receiver part #31114 because it is made in the USA and currently our most cost effective option for a front mount hitch. I called Curt and they…

The Erickson Sliding 15K Truck and Trailer Winch, #E52809, was designed to mount to the channels that are found on the underside of long semi flat bed trailers. If you are needing this type of channel any semi trailer fabricator or repair should have…

When it comes to your 10,000 capacity trailer I recommend the Buyers Products Trailer Safety Chains #337B03822SC. They're made out of a zinc-coated steel. They're 22 inches long and the link diameter is 3/8 inches. I attached a review video…

I went out into our warehouse and pulled a Sliding 15K Truck and Trailer Winch #E52809 to measure it and found that the bracket measures 5-1/2 inches wide by 7-1/2 inches long with a height of 4 inches. If you add in the reel the width goes up to 8…