Front Mount Trailer Hitch Installation - 2006 Ford F-350 Video

The front-mount hitch you referenced, Curt #31038, is a correct fit for your 2003 Ford F-150 4 x 4 with factory tow hooks. You will use the original hardware that secures the tow hooks in place, along with the two supplied carriage bolts that come…

There are virtually no structural differences between the Curt Front Mount Trailer Hitch Receiver part #31114 and the Draw-Tite Front Mount Trailer Hitch Receiver part #65022 for your 2000 Ford F-250. They both install in the exact same location and…

The mounting surface of the Fulton Hi-Mount Spare Tire Carrier #FHDSTC0101 will be 7 inches away from the trailer frame it is installed on and the mounting bolts of the carrier will be 4-3/4 inches above the top of the trailer frame.

For a spare tire carrier that will accommodate a spare tire with a 5 on 5 inch bolt pattern you could use a Trailer Spare Tire Carrier #DL22128. If you are interested in a hitch mounted spare tire carrier for a 2x2 hitch shank I recommend Curt…

I measured the u-bolts in the Fulton Hi-Mount Spare Tire Carrier #FHDSTC0101 and found them to have the following dimensions which I have noted on the linked photo. Overall length 6-1/2-in. Inside width 2-in. Outside width 2-5/8-in. Material diameter…

The best option I have to install a 12 volt power outlet in a truck bed would be to use the Hopkins 12-Volt Power Socket with Power Wire and Fuse Assembly part #HM55115 and wire this directly to the battery. This would need to be wired directly to…

I do have an option for you but the only Curt Front Mount Trailer Hitch Receiver option for a 2004 Ford F-350 is part #31114.

The Fulton Hi Mount part #FHDSTC0101 would be a great solution as it has the capacity for your 55 lb spare and is compatible with 6 lug trailer wheels.

This is correct. If you have the Blocker Beam on your 2006 Ford F-350 you will need to use the Draw Tite hitch #65022 or if not you'd need the #31114. The blocker beam is a small sub-bumper behind air dam.

Since the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle #F35FV and the helper springs like the #SSR-127-54 install at the same spot you will only be able to install one of them on your 2019 Ford F-250 4WD, but you will also…

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

What you are referring to is the lower front crossmember, and if your 2007 Ford F-350 Super Duty does have that crossmember you can definitely install the Curt Front Mount Trailer Hitch Receiver #31114. You will simply remove it (starting at about…