Amperage Draw of Ventline Ventadome Trailer Roof Vent Motor

Question

Question:

Can you tell me what the current draw on this 12 volt unit is? Thank you.

asked by: Sid B

0

Expert Reply:

The amperage draw of the motor that comes with the Ventline roof vent motor part # V2094SP-28 is 1.2 amps at 13.6 volts.

expert reply by: Jameson C

0

Answer 1

Hey Scott, so since you have a Dometic AC unit currently the replacement you'd want is the Advent Air part #ACDOM150 which was designed to replace Dometic units which means a really simple install that allows you to use current wiring and…

view full answer...

Answer 2

The outer flange that sticks out to mount the MaxxAir MaxxFan Mini Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - Smoke Item #MA00-04401M is 16-1/4" x 16-1/4" so as long as you have at least 2-1/2" to 3" of space…

view full answer...

Answer 3

Since you have a 6-pin connector you'd be able to swap out just the rooftop units with the Advent Air Replacement RV Air Conditioner #ACDOM150 you were looking at. You'll be keeping the air distribution boxes and wall thermostat, but…

view full answer...

Answer 4

Hey Jim, yeah the MaxxFan roof vent part #MA00-04002K would do a great job as a bathroom fan unlike what you have now as it can move a lot of air.

view full answer...

Answer 5

Furrion uses dual motor allow the fans to move cool air faster and more efficiently than a single motor like you would have with a Dometic unit. Furrion also includes a start capacitor to help store power so that the power draw when the condenser…

view full answer...

Answer 6

From what I can find of your Jingu 17.5 X 6.75 tire is that it has the same wheel size and bolt pattern as the Americana Modular Wheel w/ -0.5 Offset - 17-1/2" x 6-3/4" Rim - 8 on 6-1/2 #AM22461. It also has the same max load capacity of…

view full answer...

Answer 7

I reached out to Dometic directly and for your Dometic Duo Therm 57915.741 you need the replacement shroud #DMC98FR.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...