Availability of 1000-lb-Rated Dutton Lainson A-Frame Tongue Jack

Question

Question:

Four years ago I purchased a boat trailer that contains a jack made by Dutton-Lainson. The sticker on the trailer jack contains: Trailer Tongue Jack 1000 pound 203925B I was thinking of purchasing an identical unit and tried searching your website for “203925B” but no product was found. Do you sell this product?

asked by: John

0

Expert Reply:

We do carry trailer tongue jacks including products from Dutton Lainson. We offer the 1000-lb-rated side-wind tongue jack # DL22530 which comes without a wheel or foot and that can be installed either by welding or by bolting it to your trailer tongue. This jack provides 15-inches of lift height.

All 1000-lb-rated a-frame tongue jacks are displayed on the linked page.

I searched the Dutton Lainson website for your original part number and it no longer returns any results so it is likely to have been replaced by the number above.

expert reply by: Adam R

0

Answer 1

An A-frame trailer jack that fits your 2 inch outer tube diameter is the Dutton-Lainson #DL22530. It provides 15 inches of lift and has a 1,000 pound capacity. When fully retracted you'll have about 8-3/4 inches of clearance. Of the 2 inch…

view full answer...

Answer 2

The Dutton Lainson Trailer Jack #DL22530 that you referenced would work great for your application as its outer tubing diameter is 2 inch so it would fit perfectly in the 2 inch opening you have now. For more info on this USA made jack check out the…

view full answer...

Answer 3

The only jack we have that has that 2 inch outer diameter upper tube is the Dutton-Lainson A-Frame Trailer Jack - Sidewind - 1,000 lbs item #DL22530. If your trailer's a-frame coupler will not accommodate anything larger than a 2" jack you…

view full answer...

Answer 4

I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 9

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...