Wrench to Install Camco Water Heater Element

Question

Question:

What size socket wrench is needed to remove water heater electrod. The diameter hole size is 1 1/4 inch, but telling me what size socket wrench is needed to remove and replace electrode.

asked by: Jerry E

0

Expert Reply:

The Camco Water Heater Element # CAM02143 does not install using a socket wrench. It installs using the Camco Wrench # CAM09883 which works with a screwdriver to install any 5 inch screw-in element and 1-1/2 inch nuts.

expert reply by: Charles S

0

Answer 1

The Dometic 320 Full-Timer RV Toilet #DOM87FR doesn't have a replacement flush ball so instead you'll want to use the Dometic 510 Full-Timer RV Toilet #DOM29FR which is slightly smaller than the 320 but has the same materials and basic specs…

view full answer...

Answer 2

The replacement anode for your SW6DE water heater is part #CAM11563 while the replacement water heater element is part #CAM02143. The tool you need to remove the element is part #CAM09883. Attached is a video showing how to remove your water element…

view full answer...

Answer 3

According to Dometic, the company that purchased Atwood, the MPD 93755 is an instruction booklet. To get particulars about where the element is located, I'd need the model number of the heater itself. The number should be printed or stamped onto…

view full answer...

Answer 4

Take a look at the accompanying diagram I added for you, and you can see where the heating element is on your Atwood water heater GC6AA-10E; it is number 17 in the diagram and on the back of the unit, so the heater will need to be removed to do the…

view full answer...

Answer 5

It's actually on the opposite side of your water heater based on your picture. You need to access the other side and look for the panel I attached a picture of and remove it to access it. I attached a diagram picture that shows how to access it…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 8

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 9

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 10

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 11

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...