Power Wire Has to be Connected to Battery for Trailer Wiring Harness # 118480, 2010 Nissan Rogue  

According to the instructions that I have linked below the 5 bolts used are M12-1.25 x 35mm for the etrailer Trailer Hitch Receiver #e98846.

I was able to find the owner's manual for your 2010 Nissan Rogue and it states that if a trailer is over 1000lbs it will need to have trailer brakes. The maximum towing capacity is 1500lbs if you have manual mode, and 1000lbs if you do not. For…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

We have trailer hitches for your 2018 Nissan Rogue SV like the etrailer.com hitch part #E98846 which has a 3,500 lb trailer weight rating and would be able to possibly tow a very lightweight vehicle. But you'd have to verify that your vehicle…

It is very odd that only the third brake light on your Rogue would be acting up after installing the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118480; it really should not be possible that only the third brake light is having…

Powered trailer wiring harnesses like the Tow Ready part #118480 that you referenced have to have the battery wire run all the way to the positive post of the vehicle battery. The reason for this is so that the taillights of the trailer won't be…

On trailer wiring harness #118480 for your 2013 Nissan Rogue, you will have to connect the power wire from the converter directly to the vehicle battery. No other 12 volt source should be used. It is not recommended to attach the power wire from the…

Your Nissan Rogue doesn't have the correct brake light setup for you to be able to splice in a 4-way in the way you described. Trailer wiring requires the stoplights and blinkers to be on the same circuit whereas your vehicle has separate turn…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…