Powered Jack Recommendation for Pro Series Heavy Jacks

Question

Question:

I have a trailer with double Pro Series jacks. Can I add a power lift to this trailer, It has a crank now.

asked by: Joe L

0

Expert Reply:

There is a motor that can be added to the Pro Series Jacks part # PS1400960376. I recommend the Bulldog Powered-Drive Kit for Single-Speed Jacks # BD1824200100 which can be used for single or double jacks using connecting rod # BDCS730300.

expert reply by: Jameson C

0

Answer 1

The motor that fits Bulldog jack #BD182701 is powered drive kit #BD1824200100. The shaft on the jack is 1 inch in diameter and the pin hole for the crank is approximately 5/16 of an inch. The motor mounts to the side of the jack as you can see in the…

view full answer...

Answer 2

The shaft on which the crank attaches to for the Pro Series Square Jack, #PS1400950376, measures 1 inch in diameter. I have also included a dimensional diagram for the jack for you to view.

view full answer...

Answer 3

I spoke with my contact at Reese and he sent me dimensions of the Pro Series Jack, item # PS14009503676. I have included a drawing containing these dimensions for you to review. There is no owners manual included with these Jacks at this time. The…

view full answer...

Answer 4

It sounds like you're looking at something similar to the Bulldog 2-Speed Tandem Landing Gear #BD500154 and are trying to determine whether or not the 2-speed operation also works when an electric motor is used. The answer to your question…

view full answer...

Answer 5

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 6

There isn't a motor available for the Square Jack - 25,000 lbs TJD-25100. We don't carry any jacks or landing gear that are electric with that capacity. We have a square jack that can be used with a motor made by Bulldog. The motor that fits…

view full answer...

Answer 7

I have not heard of any complaints from customers about the Pro Series Trailer Jacks. The #PS1400800383 jack features a zinc plated inner tube and the jack is constructed of steel. The Pro Series #PS1400800383 is comparable to the Bulldog Square Jack…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 12

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...