Square Trailer Jack Compatiblility With Electric Motor Kit
Question:
Hi Im looking at the 9 3/4 travel Square Jack and im wondering if it can be fitted/ upgraded to be used with an electric motor ? Item # TJD-25100 Thanks
asked by: Adam
Expert Reply:
There isn't a motor available for the Square Jack - 25,000 lbs TJD-25100. We don't carry any jacks or landing gear that are electric with that capacity.
We have a square jack that can be used with a motor made by Bulldog. The motor that fits Bulldog jack # BD182701 is powered drive kit # BD1824200100. The shaft on the jack is 1 inch in diameter and the pin hole for the crank is approximately 5/16 of an inch. The motor mounts to the side of the jack as you can see in the picture I included. This will have a 12,000 lb capacity.
Products Referenced in This Question
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Product Page this Question was Asked From
Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 12,500 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Gooseneck Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 10001 lbs or More
- Sidewind Jack
- 26 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Powered Jack Recommendation for Pro Series Heavy Jacks
- Video: Fogatti RV Tankless Water Heater Installation - 2007 Starcraft Homestead Lite Fifth Wheel
- Shop: Ram Gooseneck Coupler w/ Load Bearing Pin - 8" Adjustment - Round - 2-5/16" Ball - 25K
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Shop: Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 12,500 lbs
- Shop: Bulldog Square Jack - Fixed Leg - Sidewind - 12-1/2" Lift - 10,000 lbs
- Q&A: Adding an Electric Motor to Bulldog Square Jack # BD182701
- Search Results: 182420
- Search Results: 182701
- Q&A: Replacement Drop Axle for Trailer with Square axle and Brakes
- Shop: Trailer Valet JXS Drill Powered Drop Leg Trailer Jack w/ Footplate - Sidewind - Side Mount - 7K
- Shop: Ramp Gate Seal Kit for Enclosed Trailer Ramp - Half Round Seal - 35' Long x 11/16" Tall
- Q&A: Brake Controller and Install Port Location for 2018 Thor ACE Motorhome Built on F-53 Chassis
- Q&A: Spare Tire Cover for 30" Diameter Tire on Gooseneck Trailer
- Q&A: Rubber Plugs to Cover Factory Puck System on 2017 Ram Truck
- Q&A: Recommended 2-Speed Tandem Jack Setup with 12000-lbs Capacity
- Video: Review of CURT Trailer Hitch Ball Mount - Fixed Ball Mount - C43JR
- Video: Curt Heavy Duty Forged Ball Mount Review C43JR
- Video: Bulldog Trailer Jack - Side Frame Mount Jack - BD182701 Review
- Shop: Gooseneck Hitch
- Shop: Fifth Wheel Hitch
- Search Results: square tube jack
- Video: Review of Ultra-Fab Products Trailer Jack - A-Frame Jack - UF38-944040
- Search Results: ultra fab power jack
- Shop: Suspension Enhancement
- Search Results: exterior rv lights