Thickness of Mud Flaps in Roadmaster RoadWing Removable Mud Flap System

Question

Question:

Thickness of rubber?

asked by: John

0

Expert Reply:

I went out to the warehouse to measure the thickness of the mud flaps that come with the Roadmaster Roadwing Removable Mud Flap System # RM-4400. Using a digital caliper, I found the mud flaps to be 0.34 inches, approximately 11/32 inches, thick.

expert reply by: Victoria B

0

Answer 1

I would start by measuring from the top of the cross bar to the ground on the RoadMaster RoadWing Removable Mud Flap System for Full Size Trucks - 77" #RM-4400. Then using some painters tape mark the mud flap about 1-2 inches from the ground.…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

The RoadMaster RoadWing Removable Mud Flap System for Full Size Trucks - 77" Wide #RM-4400 mount to the removable accessory. This can be a ball mount like you referenced, a bike rack, cargo carrier, or any other accessory. If attached to an…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the "new…

view full answer...