Is There A Handle on the Inside of the Full Size Locking Steel Flush Door Latch

Question

Question:

does this latch have a inside handle?

asked by: Scott

0

Expert Reply:

The Redline Full Size Locking Steel Flush Door Latch # L3980 does not have an inside handle.

I have attached a photo of the back of the latch and a product review video for you.

Typically, these types of door latches do not have handles on the inside. If you need a latch that has a handle on the inside you could use a latch like the Global Link RV Entry Door Latch Kit # 295-000019.

I have attached a review video of this door latch for you.

expert reply by: Victoria B

0

click to enlarge

Answer 1

For the size you listed it sounds like you need a full-sized door latch like the part #L3980 that mounts in door openings that are 3-3/8" x 4-5/8" hole. This is a very common door latch seen on horse trailer as well.

view full answer...

Answer 2

The Redline Flush Mounted Door Latch, #L3980, will mount in a door that has a 3-3/8 x 4-5/8 inch mounting hole. This latch is rust proof and will attach to the door using screws instead of pop rivets. If this latch cannot fit into your door's…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 7

The UFP H-1377 correlates to a Dexter #84 spindle, which is for a 3,500 pound axle. This will utilize an inner bearing #L68149 and an outer bearing #L44649. As this is being used on a boat trailer, I highly suggest going with the etrailer.com…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit and…

view full answer...

Answer 10

To create barn doors out of your ramp door, you will need hinges and a latch. I suggest a latch/lock system like the Universal Cam-Door Lock for Enclosed Trailers - 1" Keeper, #383200. This will use a 3/4 inch diameter pipe that you'll have…

view full answer...