Location of Brake Controller Connector 2016 Ford F53 Motorhome Chassis

Question

Question:

Hi, we just purchased a brand new Motorhome and it is a 2016 Georgetown on a F-53 chassis with the new 6 speed transmission.. The coach came with a 5000 hitch and already wired with big plug for the trailer.. What I would like to know is do you know the location of the factory plug for brake control unit and what adapter harness I will need to go from the Tekonsha Primus to factory connector Thanks

asked by: Mike P

0

Expert Reply:

The brake controller connector is located on the left side of the steering column support, as shown in the provided photo. You'll need the # 3035-P brake controller wiring harness.

expert reply by: Mike L

0

click to enlarge

David P.

6/1/2020

FYI - On my 2016 Thor Coach on an F53 chassis, I needed the Tekonsha 3035-P harness.

Reply

Answer 1

Thank you for reaching out and for the photos! We try to carry over the wiring brackets and for a long time they didn't change which is why we carried it over. With this new information we will definitely be updating our website. For your…

view full answer...

Answer 2

The feet on your motorhome's landing gear should not be bent at all, and for a SnapPad like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet #SP54FR4 you're looking to fit, it's going to…

view full answer...

Answer 3

Both tow bars you referenced will work with the Blue Ox base plate kit part #BLU93FR that you just bought. The biggest difference will be that the Avail part #BX7420 is designed to allow for better maneuverability in tight turns. This is…

view full answer...

Answer 4

You will need to confirm this for your rig, but it looks like many 2016 Forest River FR3 motorhomes do use the Lippert Components Hydraulic Ground Control Leveling System. It's not possible for us to know what system is on your motorhome…

view full answer...

Answer 5

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

view full answer...

Answer 6

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Answer 7

With the Glo Brite 122 series lights being obsolete we have found the Optronics Clearance or Side Marker Trailer Light in Amber #MC68AB or Red #MC68RB are the best replacement option.

view full answer...

Answer 8

Finding the stop light wire to connect to a brake controller can be tricky depending on the vehicle. Especially if there is very little space in which to work. You will start by locating the brake light switch under the dash and above the brake…

view full answer...

Answer 9

The Hopkins Plug-in Simple Brake Wiring Adapter #HM47715 is the harness you need to connect your Hopkins brake controller to your 2016 Thor Windsport. The connector is located near the emergency brake release handle. See the picture I've…

view full answer...

Answer 10

Actually most vehicles have a steering wheel lock built into the steering column to prevent the wheel from turning when the key is off. Also, typically when a vehicle is being flat-towed you actually want the steering wheel to be unlocked so that…

view full answer...

Answer 11

You would not lock out the steering on the vehicle being flat towed. Doing so would cause the wheels to scrub (drag sideways) when turning. The steering needs to be unlocked and the wheels will turn accordingly and straightened back out when needed.…

view full answer...

Answer 12

The Tekonsha Prodigy P3 Brake Controller, #90195, does not have an on and off switch. It will go into sleep mode after several minutes of no activity. The power draw when it is in the sleep mode is so negligible that it will not discharge the…

view full answer...