Replacement Wheel Recommendation for Dutton Lainson Jack part # DL22800

Question

Question:

Do you sell just the rubber wheel to replace the plastic ones thanks

asked by: Frank

0

Expert Reply:

We do have the replacement wheel you would need for your Dutton Lainson Jack part # DL22800. You would want the part # DL22410.

expert reply by: Jameson C

0

Answer 1

The Dutton-Lainson Swivel Marine Jacks are manufactured in the USA. These include the #DL22580 and the #DL22800 1500 lb swivel jacks. These are both galvanized steel which will do a great job fighting saltwater corrosion.

view full answer...

Answer 2

I can certainly provide those measurements for you! I spoke with my contact at Dutton-Lainson about the Pull Pin, Easy Swivel Trailer Jack #DL22800 and Replacement Wheel #DL22410. He confirmed that the inner bore of the wheel measures 0.645 inches.…

view full answer...

Answer 3

The swivel trailer jack we offer that has the lowest retracted height is the Fulton F2 part #F1413040134 which has a height of 11 inches from the center of its mounting bracket to bottom of wheel. The part #DL22800 has this height a little taller…

view full answer...

Answer 4

If the copper wire has turned black, it will mean one of two things. First, salt water somehow got through the insulation/jacket, causing it to severely oxidize. Second, it overheated and actually burned some of that jacket. In either case, I highly…

view full answer...

Answer 5

The bracket height on the Dutton Lainson Pull Pin, Easy Swivel Trailer Jack with 8" Wheel #DL22800 is 13", which is the distance from the center of the mounting bracket to the bottom of the wheel on this jack.

view full answer...

Answer 6

Yes, the Pull Pin, Easy Swivel Trailer Jack #DL22800 will fit your Detail K2 Mighty Multi Utility Trailer #K2MMT4X6.

view full answer...

Answer 7

There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…

view full answer...

Answer 8

The Dutton-Lainson Trailer Jack #DL22800 that you referenced will fit trailer frames that are up to 3 inch by 5 inch so it would work very well for you. The capacity for this jack is 1,500 lbs and can has 10 inches of lift. Check out the review video…

view full answer...

Answer 9

The wheel on the Dutton-Lainson Pull Pin Easy Swivel Trailer Jack is solid and made a poly molded hard plastic so you won't have to worry about a flat tire. The tire can also be replaced with Replacement Wheel #DL22410

view full answer...

Answer 10

These trailer jacks come pre-greased and must be disassembled to be greased when needed. Dis-assembly starts with removal of the cap at the top of the jack. I have provided a drawing that should help with dis-assembly and re-assembly.

view full answer...

Answer 11

Any of our parts that are manufactured in the USA have that noted in the item description. If you're looking for an American made product, the Dutton-Lainson Pull Pin, Easy Swivel Trailer Jack with 8" Wheel - Sidewind - 1,500 lbs #DL22800 is…

view full answer...

Answer 12

Scissor jacks are designed for stabilizing, not lifting. I wouldn't recommend you use one as an A-frame jack. You might be better off with a side mounted jack like the part #DL22800 that can be positioned further back on the trailer frame for…

view full answer...