Availability of Replacement Rubber Plugs for # DC200L-DCRP EZ Lube Grease Cap

Question

Question:

can i buy just the plugs?

asked by: Randall C

0

Expert Reply:

You sure can, they're sold in pairs as part # RG04-010 or individually as part # DC-RP.

expert reply by: Mike L

0

Answer 1

Yes,the RG04-010 Grease cap plugs fit the Dexter E-Z Lube grease caps on the Dexter E-Z Lube axles.

view full answer...

Answer 2

I do have an option for you but the Rubber Lube Plug part #DC-RP that you purchased is designed to fit a 1.18" diameter opening and will not work for you assuming the plug you measured is indeed 1.5" diameter. Instead, the better option for…

view full answer...

Answer 3

It's hard to see the diameter of your cap in the picture you submitted but it appears you need the part #DC-RP which fits a 1.18 inch diameter hole like it looks like you have.

view full answer...

Answer 4

We have the 1.18" Rubber Lube Plug #DC-RP that fits the 2.44" Grease Cap #RG04-080.

view full answer...

Answer 5

According to my research it looks like the replacement EZ Lube grease cap size you're needing is for a 1.98" hub bore which means you can use part #DC200L-DCRP for 1 grease cap or part #RG04-040 if you need to order 2 caps. Then for a wheel…

view full answer...

Answer 6

It sounds like you're looking for the E-Z Lube Grease Cap part #RG04-080 which is designed for a 2.44" hub bore. Please note, the grease cap that is designed for the hub bore is an exact figure that needs to be taken with a caliper but this…

view full answer...

Answer 7

For a 5,200 lb trailer axle hub with 6 lugs the correct size dust cap/cover is 2.44 inches like the TruRyde cover part #DC250L-DCRP. Sounds like what you ordered was the version for the 8 lug hubs which is a slightly larger size.

view full answer...

Answer 8

The replacement rubber caps for EZ Lube hubs are #RG04-010. These are the lube plugs for 1.18 inch dust cap holes in those EZ Lube Grease Caps. These are the equivalent of the 85-1. If you need a different size dust cap, we only have what comes with…

view full answer...

Answer 9

If the tow dolly uses ST rated tires (which most likely it does), then you need to keep the tire pressure at it's max psi to ensure you get the full capacity and prevent heat buildup. You will know if the tire is ST rated by checking out the size…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...