Availability of 7 Feet Long 2 x 4 Carpeted Bunk Boards for a Boat Trailer

Question

Question:

Need a pair of 7 foot carpeted 2x4 trailer bunker

asked by: Bryan

0

Expert Reply:

The longest carpeted bunk boards we currently offer is 6 feet in length. It's the CE Smith part # CE27840 and each 6-foot long 2x4 is covered in marine grade carpet.

You can easily construct some bunks yourself. Go to your local lumberyard and get some yellow pine 2x4x10 boards. You can then purchase some of the marine-grade carpet we offer, like part # CE11372. You'll need one roll per bunk, which means you'll have some scrap left over, which you can utilize as needed for other projects. You can use carpet adhesive to attach the carpet to the bunks, but a co-worker of mine re-did his bunks on a PWC trailer, he used a staple gun, and the bunks are holding up just fine 2 years later.

For U-bolt hardware to mount the bolsters, I recommend part # CE15283GA-2. These U-bolts come with washers and nuts and are made of galvanized steed. These measure 3-1/16 inches wide, and 3-13/16 inches long, and come with 2 in a package. For 4 U-bolts, you can order part # CE15283GA-4.

expert reply by: Chris B

0

Answer 1

What I recommend is to use 2 sets of the roller bunks #DL21740. Two bunks can cover the length of one bunk but you will need to trim one to fit. One set would be needed per bunk and then trimmed to fit. One roller bunk alone is 4 feet long. Normally…

view full answer...

Answer 2

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 3

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 4

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 5

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 6

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 9

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 12

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub face to…

view full answer...

Availability of 7 Feet Long 2 x 4 Carpeted Bunk Boards for a Boat Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching