Replacement Quick Level Touch Panel for Lippert Level-Up RV Leveling System

See what our Experts say about this Lippert Accessories and Parts

• Troubleshooting Lights On Left Side of LCI Leveling Control Panel # LC175225 Flashing
  Thanks for the picture! Since you're getting the lights on the left side to flash but none of the lights on the top you need to press and hold all 4 directional buttons at one time for a few seconds and release. This will clear the issue. If you are actually getting the side lights flashing and the lights on the top are coming on as well, you'd need to set the zero point calibration by pressing the retract all button 3x or by pressing auto and retract at the same time.
  view full answer...
  
• Troubleshooting a Lippert Quick Level Leveling System That Works Intermittently
  Some of the most common reasons why your Lippert Quick Level leveling system is working intermittently is usually due to a dead battery, a blown fuse, or bad wiring. You'll first want to check the fuse and make sure it isn't blown. This is going to be the easiest and the first thing I'd check when troubleshooting. Next, you're going to want to check your battery's voltage and make sure that's reading the appropriate voltage. If it's not, then you'll need to let this battery charge for...
  view full answer...
• Dimensions of Touch Panel for Lippert Ground Control 3.0 part # LC74FR
  The Touch Panel for Lippert Ground Control 3.0 part # LC74FR is 2-1/2 inches tall and 3-1/2 inches wide. The depth is 1 inch.
  view full answer...
  
• Can an Additional Touch Pad be Added Outside on the Level-Up Hydraulic Leveling System
  I contacted the manufacturer with this question. They informed me that the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System # LC74FR is the correct outside panel replacement for the Level-up system if it already has an outside panel and inside panel. They said that you would not be able to add a second panel outside if it is not already set up for two panels and that you should not move the inside panel to the outside.
  view full answer...
• How To Operate The Quick Touch Keypad For Lippert Ground Control 3.0 Leveling Systems
  Yes, the autolevel feature can be used to relevel the trailer if needed. The nose of the trailer will need to be above level before you hit autolevel button on your Quick Touch keypad # LC74FR, so you'll want to ensure that you raise the front landing gears up just above level for it to properly sense where it's at and relevel the trailer appropriately. When you're ready to hook back up to your tow vehicle you'll simply need to hit the hitch height button on your keypad and it will return...
  view full answer...
  
• Clicking Sound When Trying to Raise Lippert Level-Up
  What's the condition of the battery on the trailer? It sounds like it has a weak charge on battery. Or just check the connections to the RV battery as well and make sure the terminals are tight as well.
  view full answer...
• Troubleshooting a Lippert Level-Best Leveling System that Suddenly Stopped Working
  There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy stuff, so in this case that'd be a blown fuse. If the fuse is blown, then simply replace it and see if it works. If not, move to the battery. You're going to need to make sure that it's not dead and reading normal voltage. If it's dead, allow...
  view full answer...
• Replacement Touch Panel For Lippert Level-Up Hydraulic Leveling System
  It sounds like you're looking for the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System # LC74FR which works with the Level-Up system which your one control level up controller 807615 is designed for. I have included a product video on # LC74FR for you to check out as well.
  view full answer...
• Solution for Lippert Ground Control 6 Point Control Panel that Won't Power On
  Since your key pad isn't working it would be time to replace it. Since you have a hydraulic setup you'd need the part # LC58CJ for if you have the Lippert Power Gear system or # LC74FR if you have the Lippert Level Up system.
  view full answer...
• Troubleshooting A Dead Ground Control 3.0 Leveling System Touchpad
  The first thing to check when your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 touchpad isn't working would be the power source. If you're not getting a full 12v DC power to the system then nothing is going to properly operate. Test your power at each motor and the touchpad using a digital multimeter # PT89ZR. If you aren't getting 12v then we know the battery or an in-line fuse is the issue. If you are getting 12v and the touchpad isn't working then it's...
  view full answer...
• Does Lippert Control Panel LC421484 Work With Ground Control 3.0
  Yes, the Replacement Control Panel # LC421484 is compatible with the Ground Control 3.0.
  view full answer...
• Will Lippert Replacement Quick Level Touch Panel Work With Electric Leveling System
  The Replacement Quick Level Touch Panel # LC74FR will work for some hydraulic and electric Lippert leveling systems. Since your remote looks the same as this part it will be what you're needing as a replacement. Attached is a review video for you to check out.
  view full answer...
  
• Troubleshooting Lippert Leveling System That Flashes Red When "Hitch Height" Button is Pushed
  Typically when the Quick Level Touch Pad # LC74FR red light flashes it indicates an error and the retract button flashing green it means that the error has been reset. The issue appears to be on the extending, so it's possible that there's either an electrical issue on the motors or the hydraulic pump motor, depending on which type of leveling system you've got. If you can provide a bit more information on your leveling system and whether it's an electric or hydraulic system I can give...
  view full answer...
• Can The LC421484 Controller Replace The 425306 Controller With No Screen?
  No you cannot. The # LC421484 model controller is only for the Lippert Ground Control 3.0 and Ground Control TT leveling systems. Since your current controller is the 425306 with no screen this indicates that you have the Lippert Components Level-Up Hydraulic Leveling System. This means you will have to stick with the same screenless controller if you need a replacement. The correct replacement controller will be as follows: - Replacement Quick Level Touch Panel for Lippert Level-Up RV...
  view full answer...
• Solution for Needing Replacement Controller for Lippert Level Up System
  It sounds like you're looking for the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System # LC74FR which works with the Level-Up system. This is the touch pad "controller" but if you are looking for the actual controller you would need the part # LC88TF that you referenced.
  view full answer...
• Troubleshooting Blinking Red Light on Level Up Auto Level Trailer System
  The blinking red light indicates an error in the system. Most codes can be cleared by pressing "retract all". Hold the button if it is slowly blinking faded red because that is a jack fault. Hold until the jacks begin to retract. If that doesn't solve your problem, consult OneControl Touch Panel or OneControl App for instructions.
  view full answer...
• Troubleshooting LF Error Lippert Ground Control
  The LF error on your Lippert Ground Control System # LC358590 indicates an issue at the left front jack or some kind of short or failed power source (like a dead battery). If your battery has a good charge most likely it's a wiring issue. I recommend simply inspecting the wiring for any frayed or damaged portions that need to be replaced. Also make sure your battery is fully charged and in good condition. To clear that message Lippert states that you need to extend all of the jacks at...
  view full answer...
• What Does "Hall Power Short" Mean For Troubleshooting On Camper Touch Screen Panel?
  The hall power short error you are seeing is describing an issue where one of the wires on your hall effect jack/actuator which measures travel is shorting to a ground circuit. This is most likely along the wire on your camper but it could also be caused by the jack/actuator or controller itself. As this is more of a complicated task to diagnose you might consider having the work completed at a service center especially if your camper is under warranty. You can also try changing out the...
  view full answer...
• What To Do When The Middle Jacks On A Ground Control 3.0 Will Not Extend
  If the middle jacks on your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC675817 are not extending when using the auto level feature and you're not receiving an error code then you'll want to complete a Zero Point Calibration to reset the system. I've attached a little snippet from the manual below that goes over how to do this. If you do start seeing error codes then let me know and we can start figuring out what's causing the problem.
  view full answer...
  
• Troubleshooting Lippert Level Up System Taking Long Time to Work After Pressing Buttons
  I reached out to my contact at Lippert regarding the issue you're having with the Level-Up Hydraulic System on your trailer/RV. He said the symptoms you described are likely due to a faulty touch pad, but there is one thing he wants you to check before replacing it. If you unplug and remove the touch panel there will be a black and green wire behind it. The green wire is for ground and the black wire is for power. Make sure the green wire is securely attached and use a circuit tester...
  view full answer...
• Electric Auto Leveling System Replacement Panel
  I have a solution for you but the Replacement Quick Level Touch Panel for Lippert Components Level-Up Hydraulic Leveling System item # LC74FR replaces the Quick Level auto-leveling control pad for your Lippert Components Level-Up hydraulic leveling system. For an electric auto level replacement control panel you will want the Replacement Control Panel item # LC421484 if you have the Lippert Ground Control 3.0 or Travel Trailer RV Leveling System. If you have the 4-Point Leveling System...
  view full answer...
• Troubleshooting Red Light Flashing of Lippert Quick Level Touch Panel
  I would try unplugging the touch panel part # LC74FR and plugging it back in to see if that clears out the light. My guess is it just has a weird internal bug from being on the charger for so long and that will clear it up.
  view full answer...
• Is There Any Way to Control The Middle Jacks On The Lippert Ground Control 3.0 Independently?
  I do have a way which has proven to help control the middle jacks but at this time Lippert does not offer a control panel which allows for operation of just the middle jacks. The Panels # LC74FR and # LC83VR you have along with the Aftermarket Panel # LC421484 for the Lippert Ground Control # LC675817 only allow the middle jacks to lower and stabilize your 5th wheel after the front and rear jacks have leveled the camper. There is a work around which allows you to confuse the system. This...
  view full answer...
• Troubleshooting Lippert Ground Control Not Working With Red Light Only On Exterior Touch Panel
  If the Quick Level Touch Panel # LC74FR has a solid red light it is indicating low battery power to the system. This would explain the interior Touch Screen Panel # LC83VR not powering on as well. Be sure to test your battery and check the power terminals for a secure connection. Most faults can be cleared by holding retract all on the touch panel. Otherwise you will need to check the fuses and connectors for the interior touch screen to determine the fault and correct the issue.
  view full answer...

Do you have a question about this Accessories and Part?