Replacement Inner Slide for Demco DA91 Actuators - Primed Finish

Video Transcript for Review of Demco Brake Actuator - Replacement Inner Slide - DM12808-97

Hello everybody, this is Jeff at etrailer.com. Today we take a look at this replacement channel down, inner slide mount with the prime finish for your Demco DA 91 actuators. Now this part here will replace your inner slide on your Demco DA 91 break actuator. This inner slide sometimes can be bent or damaged so this was the piece that would replace it if you happen to damage yours. The center slide is the section of the brake actuator that'll actually slide inside the outer case of the actuator when your brakes are applied in the tow vehicle and when sliding back, it applies the force to the master cylinder in the actuator to apply the brakes on your trailer. This one here we mentioned is an adjustable channel, has five different mounting positions for your coupler.

Now the coupler's not included. We do sell that separately on our website. This is a channel down design. If you notice how it goes down. Basically this allows for a greater drop of your coupler, which is great for leveling any tall trailers.

Just to give you an idea of the measurement on this coupler, the channel, 12 inches height and width on it, inside to inside is three inches. This is a heavy duty steel construction, as we mentioned, has a nice prime finish over the whole part and this part is made in the USA. But that should do it for the review on the replacement channel down inner slide mount with the prime finish for the Demco DA 91 actuators.