Filter Results
$258.30 - $286.07
$511.08 - $985.69
$477.00 - $477.00
Videos
for RV Camera System
Help Articles
for RV Camera System
Expert Answers
for RV Camera System
The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.
view full answer...The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
view full answer...The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…
view full answer...Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…
view full answer...A #93 incandescent bulb has a single contact bayonet base, and there are a couple of options for LED bulbs that will replace these. You can choose a bulb that gives off either a warm or cool light; I have added a photo showing the difference…
view full answer...I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for…
view full answer...Thanks for submitting the picture of the lights you are looking for. Based on that it looks like you are in need of a 194 bulb like the part #A194B.
view full answer...You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…
view full answer...If the light mounting surface on your older Prowler trailer is not flat enough to allow for use of caulk for sealing the rear of the RV Tail Light #30-92-001 then you might want to use a weather strip tape like #WS1412 which is 1/4-inch thick x…
view full answer...The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
view full answer...I have attached a link to our selection of 8 inch trailer hub assemblies that use the common 4 on 4 inch bolt patterns for you to filter through. To choose the correct one you will simply need to remove the current hub on your trailer and check the…
view full answer...From the looks of the photo you sent it does not look like you have an OEM suspension system on your boat trailer. I recommend securing the suspension rail to the trailer frame in a more secure manner like drilling and using bolts so that it does…
view full answer...